Dodge SRT Forum banner
21 - 21 of 21 Posts

·
Registered
Joined
·
795 Posts
1.) Pull the black inerts out.

2.) Drill a couple of small holes through the top of the bumper just above the nostril where you can't see when the hood closes.

3.) Safety wire the top of the mesh through these holes.

4.) Secure the bottom of the small mesh pieces with some safety wire run from the bottom of the small mesh pieces to the top of the large mesh pieces below.

I'll try to get a pic of the holes I drilled... Actually, I gotta put mine back in. I change my mind about them avery couple of weeks. I'll get pics of it from the back of the bumper...


 
21 - 21 of 21 Posts
Top