[imageisme01]

then i decided to take unhook emanage and it was still doing it so i un hooked the in and out for the air flow and its fine now don't know where to go from here and i'm also missing the interface harness from e-manage to silver box that then hooks up to e01 where am i going wrong here?

 

[I8URVR6]

did you get it from exhaust depot?

 

[imageisme01]

no i did not, wish i did though they didn't tak e discover so thats why

 

[imageisme01]

can you still help me out did you get nate's private message

 

[I8URVR6]

I did get nates message, and no I can't really help you as Hector sets the emanage up internally before he sends them out and the wiring harness he builds is specific to him and the unit, the raw harness is different so I'd be lost. Now if you did get it from exhaust depot, it would be easy for me to do. Sorry bro, good luck.

If you want the e01 and emanage to communicate, you need to get an A/B usb cable.

You also need the msd tach driver for the RPM pickup for the emanage/e01 to use rpm offset and to read rpm.

 

[imageisme01]

i'm about to rip it out and throw it away.. just kidding i didn't spend 1200 not to use it. so i'm stuck and don't know what to do

 

[I8URVR6]

sell it on ebay! keep the e01, just sell the emanage.

 

[funks]

Did you read SY04SRT4's E-Manage Install HowTo?

It has the settings for the internal switches and how to wire the unit up properly to the ECU.

 

[imageisme01]

yeah read it, i'm sending it to hector