Stock SRT4 front & rear Caliper Bore size?
1 - 3 of 3 Posts
Joined
·
39,113 Posts
Front is shared with the RSX, 58mm I believe. At least that's what it used to be listed as in a parts lookup. Now it's listed as a 2.125 in for the front and 1.3281 in for the rear.
https://www.rockauto.com/en/catalog/dodge,2004,neon,2.4l+l4+turbocharged,1424607,brake+&+wheel+hub,caliper+repair+kit,1720
Looks like they've fixed a lot of this over the years as I've always had to resort to getting reman calipers as the rebuild kits were never right.
https://www.rockauto.com/en/catalog/dodge,2004,neon,2.4l+l4+turbocharged,1424607,brake+&+wheel+hub,caliper+repair+kit,1720
Looks like they've fixed a lot of this over the years as I've always had to resort to getting reman calipers as the rebuild kits were never right.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
StopTech Brake Pads
Brakes/Suspension/ChassisI should have bought Hawk or Carbotech then but certainly will now.- 12
- 443
-
control arm bolt!! Help!!!
Brakes/Suspension/ChassisOk so, im changing out my rack and pinion, and control arm bushings while im at it. All was going well :clap:until i got to the last bolt on the passanger side rear control arm bolt ( the big one that mounts the arm and cross-member to the frame rail). The bolt broke loose but then so did the...- 15
- 2K
-
Strut Ride Comparison: Stock vs Koni Inserts
Brakes/Suspension/ChassisI'm trying to decide which way to go when it comes to replacing my struts. Plan is to keep the stock springs for now and then upgrade to either mopar or progress springs in the future. With that in mind which has the better ride with stock springs? Which strut, Koni Inserts or OEM, would you...- 7
- 790
-
TheFancyPanc · updated
-
Replacement control arm bolt?
Brakes/Suspension/ChassisI need to replace the bolt that is on the passenger side control arm. Is it the one that is right behind the lower motor mount and is pretty long. On the other side of the bolt there is some sort of nut that helps tighten the bolt down. My issue is when the control arm was loosened at some...- 15
- 5K
-
vschaos · updated
-
Moog Problem Solver LCA bushings bending at washer
Brakes/Suspension/ChassisHey guys. I need help. I was installing my new lower control arms with Moog Problem Solvers for the rear vertical bushing but when I went to go torque them the washer on the bushing just bends. I didn't even get to 100 ft/lbs of torque. The torque is supposed to be around 160 ft/lbs. Are these...- 2
- 345
-
baggio10 · updated
Join now to ask and comment!