Dodge SRT Forum banner

SRT-4 Clutch problem

992 views 7 replies 5 participants last post by  thispainisours 
#1 ·
My clutch slave cylinder failed on my SRT-4 has anyone else had the same problem? I posted a picture on the srt trouble section of this forum. The failure happened at 1080 miles. I still love the car.
 
#5 ·
If you can find out what failed when they fix/replace it let us know. It may have been something as simple as a seal put on backwards during manufacturing.

I have heard of several other manufacturing failures (including my map sensor), but nothing as far as a consistent failure on any one component.
 
#6 ·
hey srt4 , would that happen to be you kf6pbe???
 
#7 ·
Yes it is me in the TEXT. Thanks I have found the forum and it is nice too.
I hope that it is something extermley rare in my case with the clutch slave and I will post any info about my problem. I found my thermostat housing bleed fitting for releasing trapped air after reading about the head gasket. Good info here.
 
#8 ·
i looked around again.. i think the kid said his clucth was slipping.. so i guess i was wrong :?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top