Dodge SRT Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I wasn't sure if anyone had seen the article in the December issue of Sport Compact Car magazine or not, so I thought I would just let you know.

They put the SRT-4 on the dyno and it did 223 hp and 250 lb-ft of torque. The engineers that were there stated that the engine calibration and hardware are just a few percent from being finalized. There's a dyno sheet and specs in the article as well. Curb weight made it in at 2870. 0-60 in just 5.8 seconds. It's a real nice article. Even a photo with tire smoke. :)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top