Dodge SRT Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
26,203 Posts
Remove the rubber booty.

Each pedal should have four corner brackets if a standard aftermarket pedal.

Aligned the pedal on the metal pedal and tighten upper left then lower right and not to tight.

Then apply the upper right and lower left

When you have the pedal on correctly then tighten the screws to the rear nut tight as possible.

Check the for any movement on the pedal. If so then readjust and apply sequence for safety.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top