Dodge SRT Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter #1 (Edited)
:redblob" :blueblob:

Woo-hoo!!! I just got off the phone with Neil at VEI who helped install a boost gauge in an SRT-4, so that he could get a first-hand look at what mods needed to be made to the stock pod. In his words, it was one of the easiest installs, in spite of having to modify the stock bracket. And he's looking into providing the bracket so you don't even have to do that if you don't want to. :clap:

Thanks to Chris for allowing him to be involved!

He's got photos and will do a write-up soon, but I'm going to see if I can get involved with that to speed it up. I'll actually try to have something by tomorrow. Watch this spot!!! :readclose

:redblob" :blueblob:
 

·
Registered
Joined
·
132 Posts
Discussion Starter #2 (Edited)
:clap: :thumbsup: Here it is, and no custom bracket even required... http://veisystems.com/installs/srt4/

Post your comments, suggestions, etc. Also it seems that Neil did not get any good photos of the wiring, so if you want to donate a good photo of the fuse panel and the +12V and ground wires behind it I'll gladly accept. :thumbsup: Chris, thanks again for the use of your car for this!
 
1 - 3 of 3 Posts
Top