Dodge SRT Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I need to replace the high pressure hose. All done except for the rack connection. Manual just says unbolt. Got it, but not seeing the clearance for any tool I am familiar with. I can see a little more room if I remove the return but don't see the clearance for that either. Anyone done this without removing the engine? Any suggestions much appreciated.
 

·
Premium Member
Joined
·
4,878 Posts
you could always lower the k-frame to give more room if need be, but a wheel alignment would need to be performed afterwards.
 

·
Registered
Original Owner '05 SRT-4 S2 Toys
Joined
·
169 Posts
I agree. I had a new rack installed at the same time my K-frame was replaced so I imagine it made it much easier for the tech to reach everything.
 
1 - 3 of 3 Posts
Top