Raptor BOV install

O.K. I'm ready to swap the Mopar BOV conversion for the Raptor BOV and a Turbonetics UHP. I can do all the mechanical work and have the block off plate, I just need to know about the vacuum and pressure feed to this new BOV.

Do I reuse the existing nylon hard lines or do I tee off a vacuum source from the intake?? What feed goes where?? I was reading about a "boost sensing line", WTF is that and where do I hook that up??

I'm really pretty mechanically inclined but am a newbie to turbocharging so sorry if my questions are a little lame to you guys but if you never ask, your never gonna know anything right!!!

Thanks in advance for your help.

SuperShadow