Dodge SRT Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
917 Posts
Discussion Starter · #1 ·
Ok my question. we have a full powdercoating system at my work, so i am going to take in my valve cover and have it done, my question is when getting all the edges some will get on the underside of the valve cover. Will this matter or do i need to figure out a way to stop that? if so any sugestions? may sound retarded but i dont know. thanks guys

also i figure it will be easiest to do the whole thing and then take the paint off the letters and polish it afterwards.

thanks
nick
 

· Registered
Joined
·
5,122 Posts
I had mine done by Mopar211 and I had absolutely no residue (overspray coating) on the underside of the cover.

I had a CRX cover done once at a local shop and it looked like crap on the inside. Couldnt get that stuff off. Maybe just putting some plastic down there will avoid it.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top