Dodge SRT Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3,692 Posts
Discussion Starter #1
For all of you SRT-8 owners out there, you now have a cost effective solution for your intake needs! The pictures will tell all, but the entire runner, AND the entire plenum area have been shaped and polished for improved airflow. I have seen a few competitors that have only shaped and polished the last two-three inches of the runners and that is just not good enough! There is a little more than 10hrs of portwork to get these to perfection!

Pricing is at $695 for the ported intake and if you are after the advanced ceramics package that has a thermal dispersant on the exterior, thermal block on the flanges, and a thermal barrier on the bottom plate, then add $125.

I'll let the pics say the rest! :eveilgrin

 

·
Registered
Joined
·
3,692 Posts
Discussion Starter #3
:eek2:WoWWWW!!!! look at that shiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiny intake!!!!

how much you gain with that?!? 30whp!? 40whp?!
Heh, thanks for the compliment. We are seeing typical gains in the 30whp range. Mike's (@ bwoody) wife was the first to experience thins portwork on a jeep srt-8 and they picked up 2/10ths in the 1/4 from this alone :eveilgrin
 
1 - 4 of 4 Posts
Top