no bus? HELP ASAP!!!!!

553 Views 2 Replies 3 Participants Last post by neonelite10, Oct 1, 2004

kotu100

Discussion Starter · Oct 1, 2004

i was just drivin down the road today and my guages stopped working, all the lights came on (seatbelt, oil, check engine, ABS, BRAKE, etc.) however when i go to check the trouble codes nothing show up... i tried disconnecting the batt. but it didnt work. the car runs fine but none of the guages work. HELP!!!!

Save

1 - 3 of 3 Posts

squelch

· #2 · Oct 1, 2004

Ive seen this in earlier regular neon's, maybe its similar to the srt-4. Anyway, behind the guage cluster there is a printed circut board. They had a ground problem. A bad ground will take out all the gauges, this could be your problem, not shure though.

Save

neonelite10

· #3 · Oct 1, 2004

what mods and

squelch said:
Ive seen this in earlier regular neon's, maybe its similar to the srt-4. Anyway, behind the guage cluster there is a printed circut board. They had a ground problem. A bad ground will take out all the gauges, this could be your problem, not shure though.

Does your mileage show, if not shat mods do you have?.......anything tapped into the electrical system of the cars body control module? I would say take it to the stealership unless you have any electrical mods that may be questionable.

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month