Dodge SRT Forum banner

Modify rear bumper to match Charger Srt

1787 Views 8 Replies 5 Participants Last post by  US4tuner
2
I'm considering of modifying the rear bumper of my Srt to add the air vents similar to the newer Dodge Charger Srt. Anyone have any thoughts on this? I always felt the rear bumper needed some sporty touch to it.

Also what's the proper name for that? Sourcing a Charger Srt bumper just to cut it up is too pricey. I feel like finding a aftermarket ground effect bumper for any random car might be cheaper.

Automotive lighting Leg Human body Automotive design Bumper

Automotive tail & brake light Vehicle Tire Wheel Automotive lighting
See less See more
  • Like
Reactions: 1
1 - 9 of 9 Posts
A horrible attempt at photoshop

View attachment 148691
Use the rubber stamp tool to color match and just pretend you have it :D
It would be tough to try this on an actual SRT4 bumper because the existing offset line wouldn't match all that well with the inset. Otherwise a person could probably trace out where they want it and use a dremel or some other small tool to do the cutting, then use a similar material as the bumper is made of to cut out two triangles top and bottom, and mold everything together using a fiberglass or other type of epoxy including rounding the hard edges, sand it down, sand the inlet side flat and straight so you can put some sort of screen covering on there.

Simple! LOL
just an FYI its been done before. It didnt look bad, but damn that seems like a lot of work for such a small detail.
  • Like
Reactions: 1
just an FYI its been done before. It didnt look bad, but damn that seems like a lot of work for such a small detail.
I have to agree. Maybe a project for down the road. But I hope to get it done. Right now to much more important issues to contend with.
Plan would be functional as well if I went all out and did it.
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top