Dodge SRT Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,454 Posts
Discussion Starter · #1 ·
After hearing of numerous expieriences with grommets blowing out of up-pipes, getting sucked in intake tubes, etc., I guess this would be a good time to let you boys and girls in on a little secret of mine.

I have found that the use of a 2 part epoxy on the inside and outside, on the top and the bottom(when accessible) of the rubber grommet, will almost completely eliminate the grommet/sensor getting blown out or sucked in.

I havent had this fail me yet on my car and the customers cars i have done this on. :thumbsup:
 
1 - 3 of 3 Posts
Top