Dodge SRT Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1,697 Posts
Discussion Starter · #1 ·
I bought rims roja formula 5 .. apprently new.. i look in the inside of the rims and notice 2 of the rims the welding was different from 2 of the others.. Should they have been all welded the same ? or am i just tripping.. im thinking these have been redone by someone.. they are a two piece rim

Good




??



 

·
Registered
Joined
·
1,572 Posts
Looks ok to me.

Ive been around wheels while they were being made. Just looks like a weld table issue. (table wheel mounts to and spins at a set rate as weld it is placed)


Basicly it means at that weird area that you see may have been spun on the weld table slower than normal and the weld built up.

Or at Quailty inspection time there was a flaw in the weld there and someone fixed it and went over it by hand. This is normal for companies to do this.


I think your good to go I'd have to be there to say for sure and maybe get a magnifying glass but I'd run em.
 

·
Registered
Joined
·
8,630 Posts
hmmm granted Roja's are expensive as hell.. You should ask the person you bought them from or call Roja directly. Honestly, I'm sure it'll be fine... they're probably balanced and even... but still. =)

:meow:
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top