Dodge SRT Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
11,093 Posts
Discussion Starter · #1 ·
If you notice, most alarms have 6 tones to it that repeat its self. SOme times its hard to tell if the alarm going off is yours in a parking lot etc.


Well you can change that. Take the 2 srews off on your siren located inside the horn. Get to the circuit board. YOu will see 6 traces of wire located next to each other. Each trace represents a tone. So if you cut 5 traces, you will have only 1 tone. If you cut 3 traces, you will then have only 3 tones cycling.

No , dont bother asking me, I dont know which is which and if I recall, the traces are not in the same order as the tones.


PS

Happy Boostin
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top