Dodge SRT Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Friend's srt-4 had a piston ring failure at about 400whp, running a t3 60-1. In the process of rebuilding, we would like to sleeve if possible, but do not know if they have been developed yet. If anyone can point us in the right direction, it would be appreciated. Thank you.
 

·
Registered
Joined
·
868 Posts
well...

being that it is a cast iron block, we don't have sleeves. So no, you can't resleeve the block.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top