Dodge SRT Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter · #1 ·
DynoJet run. Run conditions where 83.59 degrees F. SAE:1.02
Max power was 240.03. Max Torque was 269.87 ft-lbs (hit 270 on previous run but less hp).

Just wonder if these were good numbers. My mods - BDJ's dump style exhaust with a power effects muffler. Magnecor plug wires. AGP billet WGA set at 17 falling to 13 at redline. JLM billet engine mount. Leading edge lubricants oil. Stock airbox and stock filter. Removed filter and gained 5 whp.
May post printout when I get time.
 

·
Registered
Joined
·
1,363 Posts
wow i feel ALOT better about my dyno runs then...
106 Degrees and 82% Humidity
best run was 225.1 hp and 252.2 tq.

Mods in sig. Not sure if it was SAE corrected, doesnt say on my sheet it was Dynojet tho.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top