Dodge SRT Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
576 Posts
Removed them when I was making room to replace the Intake Manifold Gasket. Both of them have the ends broken off and are stripped, so they can't be tightened completely.
View attachment 149578
Anyone have a part number? Idea how they broke to begin with?
Not sure on part numbers, but personally I'd run a tap through to clean/recut the threads and just buy any new bolt of the same material from the hardware store at the appropriate thread pitch and length. There's not a lot of material there, but there looks to be enough to oversize if needed.
 
1 - 3 of 3 Posts
Top