Dodge SRT Forum banner
1 - 1 of 1 Posts

·
Super Moderator
Joined
·
16,978 Posts
Not sure on part numbers, but personally I'd run a tap through to clean/recut the threads and just buy any new bolt of the same material from the hardware store at the appropriate thread pitch and length. There's not a lot of material there, but there looks to be enough to oversize if needed.
I've never looked that closely, can a person run a hole clean through and just use a bolt with a nut, washer, and lock washer on the bottom side?
 
1 - 1 of 1 Posts
Top