Dodge SRT Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
667 Posts
Discussion Starter #1
I swapped back to my stock springs after having the horrible "Sportline experience". Never again will I buy Eibach springs.

:tongue:

Anyway, when I was swapping them back, I noticed my pass side axle looked like the knuckle was pulled out of the rest of the axle. I pushed it back in, but I'm pretty sure it wasn't supposed to be that way.

I took the car to the dealer today and I'm keeping my fingers crossed that they will figure the prob with the axle out and get it swapped w/o problems.
 

·
Registered
Joined
·
3,169 Posts
the tripod falls out of the cv housing if you pull it out too far but if u were able to pop it back in and install it and drive the car, all is good..

i know this because i did that once when installing a brand new drive shaft but couldn't pop it back in without tearing the boot apart so instead i brought it back to the dealer and they replaced it no problem...
 
1 - 2 of 2 Posts
Top