[Bryan]

Ok well at one point i was able to boost about 17 psi. Now im to the point to where it wont even boost 10 with a boost controller. Ive put everything back to stock because i was going to take it to the dealer but decided not to. Anyways, it was hitting 13 and some people on here said to reset the ecu and i did, and now it only hits 10. Anyone have any ideas as to what this could be? I know its not a vacuum leak because i have everything ziptied down.

TIA,
Bryan

 

[NCNTRL516]

ecu is cutting boost b/c i'm assuming its colder out... have no fear ur hp will stay the same cuz the ecu adjusts fuel maps also if i'm not mistaken

 

[Bryan]

its actually been pretty warm here, but the fact that i want to be boost 17 and i have the MBC set for 17 (they say 1lb=1 turn) makes no sense. Even stock boost is like 14. Im lost and have no clue what to do. Any other ideas where i can look?

 

[Bryan]

anyone???

 

[qwiksilvertrav]

Sounds like a boost leak. Tight all your IC hose clamps etc. Boost leak test might not hurt either.

 

[Srt4Par]

like nc said your ecu is probly droping boost b/c its colder or your mods.

still same PAR just not same boost

 

[Bryan]

thanks for the input guys. i got it to boost like 17 or 18 by putting the AGP WGA back on and turning up the boost. I still get a slight "pop" when i step on it and i dont know what thats from but hopefully i can figure it out.