Dodge SRT Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,922 Posts
Discussion Starter · #1 ·
Been a while since I've been here, hope everyone is doing well.

I got a 3D printer for Christmas as designed some shifter bushings for my new "to me" 2gn.

These are similar to Boogers in design and if you don't like to tinker I'd highly suggest you buy his.

I made these in PLA+ because it was the only stuff I had laying around.

Had to hit the center portion where the pin hole necks down with a little heat to soften it so it didn't break.

Just got a spool of TPU in and I think that will be a much better material to make these out of, but the PLA seems to be doing just fine so far.

All of the files are in the attached link below and you click and print, or edit the overall design in Fusion 360 (free personal license) if you so desire.

Link
 
1 - 1 of 1 Posts
Top