Dodge SRT Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
My Caliber starts and runs fine unless it revs above 3000 rpms. If I am not paying attention and I let it pass the 3000 mark (mainly when doing 40 mph or faster, but has occurred below that), the engine will feel like it bounces and the system throws a p0300 AND P0315 codes. My scanner shows these as a multiple cylinder misfire and crank sensor unlearned. I had other issues prior where spark plugs and wires were replaced and #1 ignition coil were replaced at a dealership. That cured a few other prior codes. I replaced the camshaft sensor and the crankshaft sensors, but still get these two codes. Any ideas?
 
1 - 4 of 4 Posts
About this Discussion
3 Replies
2 Participants
coralman
Dodge SRT Forum
The community to discuss high-performance Dodge vehicles from the SRT and PVO groups, SRT-4, SRT-6, SRT-8, and SRT-10. Come join the fun!
Full Forum Listing
Top