So i got the fcbc. I got a couple of problems. One is that my map load is reading 49xxmV and it never changes. My rpm has nothing. And the main thing is the boost guage on the dtec reads ~1 psi all the time no mater what. Ive put like 200 miles on it since the install and it was driving fine(same problems i think i had the game boy off most of the time) but i started it today and it runs like shit. CEL p0108 which is map to high. In the manual it says to calibrate the input 1 and output 1 or cal input 2 output 2 for the boost gauge per the "calibration sheet". I dont have a calibration sheet. So basically am i supposed to calibrate tps,map,rpm, etc or should it work when i turn it on.
Im not sure they are all related so if you can help with one please chime in.
Whoever has a DTEC help me
Linear Mode
