a few questions - SRT Forums

**tgspeedracer** · 04-12-2009, 04:44 PM

Ok I am running high boost, will the factory boost controller handle 30-40psi?

If so I need to hook it up and cant remember where wg, and boost lines plug in?

And I think I need the "RED" line connected and not sure where that one goes eather.

Next question, If I need a more than 3 bar map sensor, can I use a 5 bar and where can I get one (what manufactor makes one that will work in our cars)?

nemiro · 04-13-2009, 09:56 AM

It will handle it, if you have the sensors and tuning to go with it. If you want the PCM to run it, then you need the vacuum lines hooked up with way the PCM expects them to be - stock.

julius717 · 04-13-2009, 04:58 PM

newb

91PumpKing. · 04-13-2009, 05:27 PM

you will need 2 AEM 3.5 bar sensors. i think those are good to 35 or 36psi. those will replace your 3bar map/tip.

there are 5bar map/tip, but you will have poor resolution quality, and unsure how that would affect your tuning.

**tgspeedracer** · 04-13-2009, 07:55 PM

anyone have the stock vacume charts?

nemiro · 04-13-2009, 09:22 PM

Should be on your hood decal.

**tgspeedracer** · 04-14-2009, 07:50 AM

Quote: Originally Posted by nemiro

Should be on your hood decal.

thanks