Ported Stock Setup

[MiskaTorn]

This is my ems car with the FBM intake manifold, exhaust manifold and turbo combo.

This was done at 19psi with a surging boost problem that we are guessing is a result of too small of turbo.

Please note this has been done on a mustang dyno which can be anywhere from 20-50 hp less than a dynojet. Once the setup is complete I will get dyno sheets from both a mustang dyno and a dynojet. I do not know which one is more accurate as there's tons of debate and arguing about that, I'll leave it for you to decide.



Also this was done on 92 octane gas. I will try to remove the mods that aren't power addons so you don't have to sift through.

Here is my current mods list:
AEM EMS
FBM Intake Manifold
FBM Exhaust manifold
FBM Stock Turbo
3 MPx in turboback catless exhaust
3 MPx inch O2 Housing
5.2 Bar MAP Sensor
70mm Boomba Throttle Body
8.5mm Spark Plug Wires
K&N Cold Air Intake
Boomba Fuel Rail
AGP Fuel Return Line Kit
AEM VSS Boost Controller
Pressure Pipe with Raptor BOV
AGP RACE Front Mount Intercooler
650cc Injectors
Walbro 255 Fuel Pump
AGP Wastegate Actuator
DCR Oil Restrictor

EMS File

[never2muchboost]

Quote: Originally Posted by MiskaTorn

This is my ems car with the FBM intake manifold, exhaust manifold and turbo combo.

This was done at 19psi with a surging boost problem that we are guessing is a result of too small of turbo.

Please note this has been done on a mustang dyno which can be anywhere from 20-50 hp less than a dynojet. Once the setup is complete I will get dyno sheets from both a mustang dyno and a dynojet. I do not know which one is more accurate as there's tons of debate and arguing about that, I'll leave it for you to decide.



Also this was done on 92 octane gas. I will try to remove the mods that aren't power addons so you don't have to sift through.

Here is my current mods list:
AEM EMS
FBM Intake Manifold
FBM Exhaust manifold
FBM Stock Turbo
3 MPx in turboback catless exhaust
3 MPx inch O2 Housing
5.2 Bar MAP Sensor
70mm Boomba Throttle Body
8.5mm Spark Plug Wires
K&N Cold Air Intake
Boomba Fuel Rail
AGP Fuel Return Line Kit
AEM VSS Boost Controller
Pressure Pipe with Raptor BOV
AGP RACE Front Mount Intercooler
650cc Injectors
Walbro 255 Fuel Pump
AGP Wastegate Actuator
DCR Oil Restrictor

EMS File

have any logs? the tune looks good but seems like torque rolls over pretty hard what is it doing up top?

[MiskaTorn]

Quote: Originally Posted by never2muchboost

have any logs? the tune looks good but seems like torque rolls over pretty hard what is it doing up top?

I'll try to get some logs this weekend when I drive around. Up top the boost surges really bad. Boost goes in and out. I'm not sure what the cause of it is and haven't had a chance to do much testing with it to try to resolve the problem.