Air/Fuel Reading - SRT Forums

**jec1980** · 01-15-2009, 12:23 AM

Ok, this has most likely been answered here before but as I don't have the time to search every entry; I'm asking this.

If I already have the Aeroforce Scan gauge, can I get away with only purchasing the wideband sensor (02 sensor)? or do I need the whole UEGO setup? From what I've read, the sensor wires up to the analog input cable without the need of the gauge and other accessories, is this correct?

The reason I ask is, I don't feel like spending any more money then is required.

**jec1980** · 01-16-2009, 08:40 AM

BoostingSnail · 01-17-2009, 11:30 PM

I run the AEM wideband w/ guage and the 5V output is a wire that comes from the back of the gauge, so you need to run the guage as well with this setup. Im not too sure about the other AEM stuff though or other widebands for that matter...hope i was of a little help to you.

**jec1980** · 01-19-2009, 09:25 AM

Quote: Originally Posted by BoostingSnail

I run the AEM wideband w/ guage and the 5V output is a wire that comes from the back of the gauge, so you need to run the guage as well with this setup. Im not too sure about the other AEM stuff though or other widebands for that matter...hope i was of a little help to you.

I was trying to avoid cluttering my dash up with gauges, so I might as well just run the AEM gauge.

forcefedjunkie · 01-20-2009, 03:34 PM

You need the controller to go with the wideband sensor. I use the AEM as well, with the AEM gauge/controller tucked under the dash.

Todd

**jec1980** · 01-21-2009, 07:46 PM

Quote: Originally Posted by forcefedjunkie

You need the controller to go with the wideband sensor. I use the AEM as well, with the AEM gauge/controller tucked under the dash.

Todd

Yeah, that an option.....just wish the wideband controller through Aeroforce was available.