clutch slave cylinder and master help - SRT Forums

kc21balla · 12-01-2008, 08:14 PM

Ok I am about to start a swap and i have some questions just to prepare me. First question: Is there anyway to tell if a clutch master and or slave cylinder is bad? the connect point is connected

There are a couple tabs o the slave that im not sure about if they are broken or not.

the other question I have is the rubber piece on the slave cylinder I will post pictures later but i dont know if its in the right place..

thanks for the help oh and sorry for the bad pics.. I only have my cell phone right now.

NeonDan · 12-01-2008, 08:32 PM

is your car an 01+

kc21balla · 12-01-2008, 09:06 PM

its an 03 and the pictures are from the slave and master cylinder from an srt that i will be swaping into the 03. just want to know if they look in working order

thttxboy · 12-01-2008, 09:10 PM

Sup Kyle why dont u just buy a new slave cylinder and call it good insurance??? Their not that expensive and you will feel better anywayz

kc21balla · 12-01-2008, 09:16 PM

because if i can save some money that would be huge. especially right now being christmas time and all. i dont see anything wrong with it it only had 16000 miles on it i just want to make sure all the tabs are there and stuff.. but yeah

thttxboy · 12-01-2008, 09:22 PM

Try it out and if its not working properly just switch it out. thier not too hard to swap out.

kc21balla · 12-01-2008, 09:24 PM

yeah thats my goal.. i dont know how to put it in to the tranny.. i cant figure it out with these tab things..

thttxboy · 12-01-2008, 09:31 PM

It goes in the side of the tranny push it into the the pivot fork. theres that plastic cover there and you should be able to see it from there. I Just replaced one for my friend and it took me like 15 mins.

kc21balla · 12-01-2008, 09:45 PM

does anyone have a picture of a new one so that i can verify.. please

kc21balla · 12-02-2008, 09:18 AM

bump any help would be great!