car bogging with meth - SRT Forums

CIVICEATER · 08-18-2009, 08:02 PM

I just finished putting a coolingmist meth kit in and whenever I wot shift the car falls on it's face. I tuned the tune knob down to 4 and it still does it slightly. When I turn the meth off it shifts perfect. Why is it doing this when I had my devilsown kit it never did this.

Adionik · 08-18-2009, 08:13 PM

What are you tuning with? Nozzle size? Sounds like you need to pull fuel. First time I fired the meth I was 10.0 @ WOT

Coolingmist · 08-18-2009, 09:04 PM

Quote: Originally Posted by CIVICEATER

I just finished putting a coolingmist meth kit in and whenever I wot shift the car falls on it's face. I tuned the tune knob down to 4 and it still does it slightly. When I turn the meth off it shifts perfect. Why is it doing this when I had my devilsown kit it never did this.

your sig says you made a deal with the Devil for a meth kit, but you say you have a coolingmist kit in your post?

Or do you have pump/plumming from them and the controller from us?

What size nozzle do you have? You should keep the tune knob between 7 and 10. You want it as high as possible. The tune is great for fine tuning, but when you drop it to 4, your pressure will be very low and your system will not be very progressive.

Lets talk details to see whats going on, however injector size is the likely culprit.

CM

CIVICEATER · 08-18-2009, 09:26 PM

I had a devilsown kit and recently switched to a coolingmist kit with varicool controller. I have no clue what size injector it is it is the only injector that came with the kit there are no markings on the injector or anything. I had a 3gph in my devilsown own kit and think that was a good size.

Coolingmist · 08-19-2009, 08:22 AM

Quote: Originally Posted by CIVICEATER

I had a devilsown kit and recently switched to a coolingmist kit with varicool controller. I have no clue what size injector it is it is the only injector that came with the kit there are no markings on the injector or anything. I had a 3gph in my devilsown own kit and think that was a good size.

Wise decision on the switch. Lets see what we can do to help you.

Did you buy this from us? or did you buy a used kit? If you bought from us pm your first/last name so I can see your injector size.

CM

Coolingmist · 08-19-2009, 06:35 PM

your nozzle was a M5. If you prefer your M3, you can use your old nozzle as well.

David