Aem water/meth kit. Need some advice please! - SRT Forums

**Green Machine** · 08-31-2009, 02:32 AM

Hello everyone! I've been looking into getting a water/meth kit since it seems to me like a win/win situation to do so... Anyways, I picked up an Aem kit model number 30-3000 located here for reference...

AEM - Water/Methanol Injection Kit with 1-Gallon Tank

I'm pretty new to this stuff and have been reading through the stickies and most of the threads, but not all. I was reading this thread made by turbojack on jet locations...

Water injection jet location points

Now, the Aem kit comes with three jets, one for low 150-250hp, medium 250-400hp, and high 400+hp.
It only says to install one in the instructions, but would it be a good idea to have 2 jets? Using the small and medium sized sprayers out of the kit, placed at the start of the cold pipe after the IC, and one after the IAT sensor, but before the throttle body? (Just like suggested in Turbojacks post above at locations 4 and 6 on his diagram) Just wanting some input from more experienced users. I currently have a modified stage 3 setup tuned by Aaron. Sorry about the long read, but I'm sure you are all used to turbojacks long (but good) reads if you are in this section! LOL

Thanks for looking, and thanks Turbojack and others for the good info!

**Green Machine** · 09-03-2009, 02:39 AM

Anyone have .02 cents?

**Green Machine** · 09-05-2009, 11:40 AM

.01 cents?

raul-01 · 09-05-2009, 01:42 PM

What size pump comes with that kit? I say tap 2 just in case. Get a plug at a hardware store and try one nozzle first and see how you like it. If you want to try something new un screw the plug and try a dual nozzle setup. I believe people had one tapped on their intercooler end tank on the cold side. Then one on the UPP.

**Green Machine** · 09-05-2009, 08:48 PM

Quote: Originally Posted by raul-01

What size pump comes with that kit? I say tap 2 just in case. Get a plug at a hardware store and try one nozzle first and see how you like it. If you want to try something new un screw the plug and try a dual nozzle setup. I believe people had one tapped on their intercooler end tank on the cold side. Then one on the UPP.

Wow, a response! The kit comes with a 150 psi pump..