Ported Head Pics - SRT Forums

ACRucrazy · 05-06-2008, 03:05 PM

So the story goes.

I found a SRT head that a guy pulled from a wrekced SRT in a yard. The price was very fair and thought it would be nice to have a spare head laying around.

Well it showed up last night and this is the head that was pulled from an SRT in the junkyard.

Anyone ever see port work like this before? (yes i know ANYONE could have done it, just curious if a common vendor does work like this)

reed32 · 05-06-2008, 03:11 PM

looks very similar to a tk head or cnc one

SRT-4_UK · 05-06-2008, 03:38 PM

CNC engraves the head like this

And I am pretty sure TK does the same

Drastic_Said · 05-06-2008, 05:28 PM

^^^ correct.

**all_motor_mike** · 05-06-2008, 11:05 PM

when i first saw it on the org the exhaust ports made me instantly think is was a cncport head but the 40 grit finish on the intake side made me think other wise. has jason always engraved his logo on the srt heads or is that a new thing? neer seen any of the tk heads so i would know about those.

mike

FraziersSRT · 05-06-2008, 11:28 PM

What did you pay for it?

reed32 · 05-07-2008, 08:56 PM

went through some photos of heads and that one is very very close to the rage-tek head.

FraziersSRT · 05-07-2008, 10:32 PM

reed32 - Hmmm,it could defanitely be a rage head.

reed32 · 05-07-2008, 11:45 PM

Look On Rage-tek Web Site The Intake Ports Look Just Like It.

Nelson · 05-07-2008, 11:53 PM

Either way, looks like a great find. If all else fails, just send it in to get touched up if needed.

**all_motor_mike** · 05-08-2008, 07:37 AM

rage teks intake side is opened up to the srt gasket (its looks like) this head does not look to be, it looks closer to a 1gn dohc neon intake manifold gasket.

mike

ACRucrazy · 05-08-2008, 10:37 AM

There are no engravings on the head, I looked it over.
I may send it out and have it cleaned up.

nutz · 05-10-2008, 02:03 PM

i dont think its a cnc or rage tech it looks like hand ported with stock valve guides

good find for 100 bucks