Stage 3 turbofold install, what is needed? - SRT Forums

SonnySrt-4 · 07-01-2009, 02:17 AM

Ok, I am gonna be installing a s3 turbofold and 02 housing.

What gaskets bolt/nuts are needed? Can I reuse my old exhaust mani gasket and 02 gasket? I heard its "better" to use the used gaskets? Does the bolts/nuts from the stock manifold/o2 housing work for the stage 3 manifold and o2?

Also is there any where I could find install instructions for the Mopar stage 3?

Thanks guys I really could use this info.

TomC3 · 07-01-2009, 07:51 AM

I posted it some time ago, or just PM S and P (Speed and Power Development) - go with their recommendation. The one area I had some difficulty with was the studs in the head - I bought 2 nuts and locktite'd them the the old stud, then was able to back out the old studs. Buy new gasket, nuts....suggest getting a new oil return pipe/line (much easier to cut the new line than the old to fit the stage3...).

top oil line is also crucial - get extra crush washers.....just in-case - this saved me a couple of times - I had some extras available when I needed them.

hydrohopper · 07-03-2009, 02:14 AM

. . .

Louisvilleguy · 07-03-2009, 10:48 AM

Here is what Jimmy put together for me when I was going to install my turbofold. This was everything I needed.

4884447AA Exhaust Manifold Gasket
4852396AB Copper Gaskets (x4) (the larger ones)
4343770 Drain Tube Gasket
5045038AA is the Oil Feed Line (the smaller ones are only available w/the line right now)
6507829AA Stud (x3) Studs in the head for the manifold to bolt
6504152 Nut (x3) Nuts to attach to the studs to hold on the manifold$4.02
6503131 Bolt (7) Bolts for the manifold to Head

I would go through S & P. Contact them through their web site or email them. They are still doing orders until August I believe.

SonnySrt-4 · 07-04-2009, 03:53 PM

Quote: Originally Posted by Louisvilleguy

Here is what Jimmy put together for me when I was going to install my turbofold. This was everything I needed.

4884447AA Exhaust Manifold Gasket
4852396AB Copper Gaskets (x4) (the larger ones)
4343770 Drain Tube Gasket
5045038AA is the Oil Feed Line (the smaller ones are only available w/the line right now)
6507829AA Stud (x3) Studs in the head for the manifold to bolt
6504152 Nut (x3) Nuts to attach to the studs to hold on the manifold$4.02
6503131 Bolt (7) Bolts for the manifold to Head

I would go through S & P. Contact them through their web site or email them. They are still doing orders until August I believe.

Do you remember the cost of that? ^^^

Louisvilleguy · 07-04-2009, 08:15 PM

Yes, it was around $65 with shipping.