How hard was it to mod the agp? I have an ebc w/ the standard WGA but I am able to spike 25+ if I wanted to and hold ~20 lbs. I want to hold 22~23 and control my spike with the EBC. Is it possible?
__________________
Hahn 20g (was 16g) w/ DW 650s , W/M, Custom 3" O2 Housing and some other goodies.
No returnline!
Anyone with the 16g or 20g kit, please let me know how you hooked up the map clamp (hans map clamp). Hahns sent a drawing of how to hook it up, it shows the mapper red wire to the map sensor middle wire and the mapper black wire to the map sensor far left wire. But I have heard people use the mapper red wire to the far right sensor wire and the black to the middle?
they have a 15 lb WG. Beyound that, you will have to use a manual or electronic boost controller to achieve that level of boost. I hooked mine up to the stock soleniod and hit 20 lbs
__________________
Hahn 20G turbo & CAI, Avid motot/tranny mounts, CCA Dircet Fit Intercooler, Turbonetics Raptor BOV, BWoody Catch Can,AGP Hotside Pipe, R&R 3" single exit turboback -cat.
ACT Street clutch, Mopar STS w/ booger bushings, Royal Puple Syncromax
Anyone with the 16g or 20g kit, please let me know how you hooked up the map clamp (hans map clamp). Hahns sent a drawing of how to hook it up, it shows the mapper red wire to the map sensor middle wire and the mapper black wire to the map sensor far left wire. But I have heard people use the mapper red wire to the far right sensor wire and the black to the middle?
find out which wires need power, ground, and signal...
then use a volt-meter to determine which wires are power, ground, and signal on the sensor...
do not go by middle, pass side, and dr. side... that's rediculous and whowever you are talkin with should be shot...
working with my map/tip clamp (and sensors during install) i found that some of the wires were the wrong color (comparing against several writeups and the FSM)...
took the adjustable portion off the hahn wga and swapped it onto the agp wga. kindof a tight fit but it will screw on. just be carefull not to thread it on crooked. as for mounting, i used the top hole on the agp wga mounting bracket and the bottom mounting hole on the front face of the compressor housing( not the ones that are welded on). 2 allen screws are on the front, they can come out.thats what i used to mount the wg. still adjustable and the angle is just right. been on bout 7mon. no issues
AutoForums.com is the premier network of enthusiast-owned
enthusiast-operated automotive communities.
We operate more than 100 automotive forums where our users consult peers for shopping information and advice, and share
experiences and opinions as a community.
Hahn 20G turbo & CAI, Avid motot/tranny mounts, CCA Dircet Fit Intercooler, Turbonetics Raptor BOV, BWoody Catch Can,AGP Hotside Pipe, R&R 3" single exit turboback -cat.
Linear Mode
