how-to instal cbd rear diffuser

[brume292]

i receive recently my diffuer but no instruction with it .so i like to know how do i have to install it ? do i need to cut the bumper ou roll it where do i have to fix the L bracket ? thank you very much

[Outlawnick]

Here is the instruction sheet that came with mine.

[carbonbydesign]

I am sorry you did not get a install sheet. Send me a pm with a fax # if you have one and I will get it right over. I can also mail it if you like.

Travis
760-643-1300

[brume292]

do u have picture of what the bumper is supposed to look like after cutting it??? cause i roll the rear bumper but its dosnt fit there at all so i don`t wanna cut it and find out that the rear diffuser have something wring

[radicalmark29]

i heard you have to have aftermarket exhaust to fit the diffuser?! true!?

[Outlawnick]

Quote: Originally Posted by radicalmark29

i heard you have to have aftermarket exhaust to fit the diffuser?! true!?

Not true. I had the stock exhaust when I installed my diffuser and it fit very well.

[JaWz]

Do you have to cut the bumper?? I have just the diffuser..no hardware...what do i need to get in order to install it without cutting rear bumper??

[carbonbydesign]

Quote: Originally Posted by JaWz

Do you have to cut the bumper?? I have just the diffuser..no hardware...what do i need to get in order to install it without cutting rear bumper??

I have heard of other people just rolling the bumper not cutting but I am not sure about that.

Travis
760-643-1300

[STV3]

Quote: Originally Posted by carbonbydesign

I have heard of other people just rolling the bumper not cutting but I am not sure about that.

Travis
760-643-1300

When i got mine it didnt come with any instructions. All it came with was the diffuser, those two support rods, and the 3M adhesion stuff. I just slid it on between my rolled bumper and exhaust and it fit ok. I end up using some small black drywall screws for some extra support for the tape