Dodge SRT Forum banner

XXR 527 new rim for 2011

592K views 1K replies 233 participants last post by  2K3PL24 
#1 ·


Hopefully these come in the right hub bore. They look really good. I just wish there was more info about them.

I was looking for 17x9's but I might settle for these when they come out.
 
See less See more
1
#236 ·
a rule of thumb to keep the same over all tire Height for ever 20mm wider you fo take 5 off the aspect ratio

for example
205/50 = 25.07
225/45 = 24.97
245/40 = 24.71


what you were lookin at

245/45 = 25.6

almost a half inch bigger than stock
 
#237 ·




My wheels finally came in
 
#240 ·
17X9.75?! That's going to be badass :)
 
#241 ·
i plan on mounting 275/40/17s on the front. and for the back i have 17x8.25s so a 245 will be holding down the ass end.. but once i get my car out of hawaii ill put the coilovers on and the fenders and rims and get it sitting pretty .... then start the build
 
#244 ·
dry carbon DCR fenders :thumbsup:
 
#248 ·
^Yup.
 
#250 · (Edited)
Alright ive got a question. Since im now interested in ordering a set in the next week im wondering which to decide. Ive read this thread like 4 times and im still deciding. Bare with me suspension isnt a thing im to familiar with thats why im trying to figure this out.

My car has BC coils on it with the front/rear plates. i dont have the car here as its sitting in a shop waiting for a clutch. It's not slammed but low enough to look sexy. PA roads are garbage so i dont want to slam this thing.

Now im thinking about the 17x8.25 +25 offset. Since it sticks out farther i have to run like a negative degree of camber all around to make these fit? Will i have to do alot of work with the fender (ie. tuck the fender or anything along these lines). As far as tire id be using the 225/45/17 or 225/40/17 for a little stretch not to much. The 35 offset should fit rather nice just looking into something more daring
 
#255 ·
Those look sick bro im digging the rear fitment
 
#260 ·
Damn those look great!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top