How do i hook this HID kit up?? - SRT Forums

Main_Event · 07-05-2006, 06:35 PM

I did it on my friends integra but the wiring i got from quickwhips is so wierd.
i dont no were these connections go. i have to draw power strait from the battery??

So the i hook up the wires that go to the ballast and the wires from the bilb to the ballast.
Now were the hell do the wires im holding go??

EssArTee-4 · 07-05-2006, 06:46 PM

Looks like a positive feed, negative feed and stock harness hook up to me....

Main_Event · 07-05-2006, 06:47 PM

ok......is there a way you can tell me what goes were?

EssArTee-4 · 07-05-2006, 06:49 PM

Looks like both the + and the - are 10 ga. wire...run those straight to your battery....The other two, Im not 100% sure, it's been awhile since I did an HID hook up

David40836 · 07-05-2006, 06:50 PM

Mabe wires for a relay or switch if these are high/low beams??????

David40836 · 07-05-2006, 06:51 PM

no instruction or support from vendor?

Army

David40836 · 07-05-2006, 06:56 PM

no instruction or support from vendor?

Army of One!!!!!

Main_Event · 07-05-2006, 06:58 PM

it came with instructions but it looks nothing like it. and no its not hi/low

Main_Event · 07-05-2006, 07:00 PM

and the ywllow one is and fuse box. and the blue connectors fits only in the old connector were it went in the old buld. so im guessing it goes in the old connector. but there is only one?? so the other side is just going to be hanging?

SpooledU · 07-05-2006, 07:02 PM

It Looks Like All You Have To Do Is Connect The Red+ And Black- Wires To The Battery And Connect All The Wires From The Ballast To The Bulb Wires And Then Connect The 9007 Harness To The Stock Harness And Thats It

David40836 · 07-05-2006, 07:07 PM

Pass me on the vendor?

haknslash · 07-05-2006, 07:49 PM

can you take a larger pic of the entire harness?

The blue plug looks to be your tpical 9007 plug. You would of course attach it to your stock 9007 plug.

The yellow thing from my vierw looks to be a fuse holder. One end would go to postitive term. on battery and the other should go to your ballasts or hopefully, your relay harness.

2acrguy · 07-06-2006, 06:30 AM

haknslash is correct nothing to it at all

just plug the blue plugs into your stock headlight connectors and hookup the power and neg. wire to the battery, mount the boxes and you are done

All you had to do was pm me or e-mail us

Thanks
Richie