How to after swap - SRT Forums

srt4-denmark · 07-05-2006, 04:02 AM

Hi I´m a new member here. I come from Denmark so please be patient with my spelling. I have just finished making a swap from 04 SRT-4 bought in L.A. and shipped to Denmark. The car had an impackt in left side, only dors and panel had damage. The drivetrain and interior etc. has been buildt into a 2000 Chrysler Neon. Will post pictures later. I did let the wiering stay inside the car. The car runs great huh..., but TURN SIGNAL front right side dont work. Interior panel light dont work, engine lamp is on, and termperature wont show in car. Can anybody help mee?

haknslash · 07-05-2006, 08:11 AM

Is this a full SRT4 swap i.e. motor, trans, fascias or just the fascias your talking about?

The turn signal sounds like just a blown bulb. Check to make sure and then if the problem still persisits, break out the ole voltmeter or test light and go from there...

srt4-denmark · 07-05-2006, 09:01 AM

It is a full swap with engine, trans, interior etc. the only thing that is not swapped is front fasia, still the same from chrysler, just had to cut in it to make space for the intercooler.

YellowSXT · 07-07-2006, 10:04 PM

I have the solution... Its a little tricky so pay attention. Over the D/S kick panel is a junction box. Big black one. The only thing that holds it is two 10mm bolts. I would assume that the blinker that is not working is the one on the drivers front. you will have to cut a light green & white wire on the black side on the junction box. You have to find out what is the wire that goes to the blinker & splice into it. I had this done & I have a swap in process on an 02 Neon & I did my interior over a year ago.

srt4-denmark · 07-09-2006, 06:56 AM

THX for the advice, I will try to do it this evening, and then write back if it was the solution. BR

Diablo0 · 07-24-2006, 10:29 PM

On the grey plug that you feed through the firewall you can easily move pin 4 which is a Light Green w/ Orange stripe over to the pin 5 location. In 00-02 the front drivers turn signal wire was in the pin 5 location, in 03+ they moved it to the pin 4 location. On the front of the connector you'll see a little word next to the red bar saying "lock" move that over then use a small paperclip or sewing needle to release the wire to pull it out and move it to the pin 5 location. Pushing it in will secure it then move the red lock bar back to secure all the pins in the connector. Be careful moving the lock bar as the little tabs where you put a screwdriver break easily.