anyone have this problem...

[kerry123]

So i bought the Autometer Cobalt guage to replace with my stock one...i get the stocker out and go to install the new one...the new gauge is too long...it would stick out like a half inch out the pod if i were to install it....anyone know what 30-30 boost gauge works without needing to modify the gauge pod....also product numbers would be very helpful...again i would like to keep the cobalt any clues on what to do....Thanks

[goats srt]

u can
A=wrap the white part of the gauge with elec. tape so that u dont see the white part
B=get a gauge that doesn't light with a LED

[VampOfVegas]

Hack up the stock pod? Cut some dash? Buy a pillar pod and put a WB in the stock hole.

[alias56]

Quote: Originally Posted by goats srt

u can
A=wrap the white part of the gauge with elec. tape so that u dont see the white part
B=get a gauge that doesn't light with a LED

I did this ^^^ and it doesnt look bad.

[$PK$]

I have an autometer 30/30 from modernperformance.com and it fits fine. no modifying at all.