- EManage or psi-fi powerpaq.....that is the question
- Higher Revs Please
- Ignition timing questions (and nitrous too)
- Is this a good deal for used emange?
- Does anyone have the profec b II wiring diagram?
- Turboxcfuel cut defencer or map clamp and wideband?
- Emanage now commun. with E-01 and error on emanage Help...
- Profec B Spec II & E-01 Boost Solenoids the same??
- power paq users
- Fellow e-manage & e-01 tuners, I have ??'s
- Im sure this has been asked 800.000.000 times but I need your help
- need an E-01 for use with emanage?
- is this odd? Speed option on Boost setting on E01? as well as display option?
- LM-1 and Eo-1
- Calling Nivo and others.....
- E01 display needed? And tip nod for S0 back on for S1 & eman / E01?
- Stage 2 Mopar Kit and PSI-FI Power Pack
- E-01 display
- got a map question
- E-01 and emanage question
- Greddy e01 initial setup
- Safc Help Please
- Need Someone To Tune car with Emange(PA/NJ)
- PLX Devices
- Easy e-manage, e-o1 question?
- Stage 2 with toys and 100 Octane on A/F
- Stand alone - questions, dave/dynoworks maybe some input from you also?
- S2 W/o Toys How Much Boost Is Ok
- Wide Band O2
- Question for turbo/engine managment gurus.
- S1,agp,AVC, ok with RC550 injectors?
- Engine reliability with upgraded stock turbo and 20+ lbs. of boost
- PsiFi's SRT400 kit
- question about Apex-i Super AFCII
- VC2 Map Clamp
- would it matter iif i used fuel lines instead
- question on eman and e o1
- Thank Jesus for the greddy profec spec b!!
- whats holding me back at 15psi?
- Powerpaq or eman
- Why do I want e-manage instead of SAFC?
- IS there a way to test a to see if a map clamp is fried
- ?? for tuners
- another e-manage question (logs)
- Techedge DIY wideband is done!!
- Engine Management , cant decide between stage2&safc2 or e-manage&e-01
- New Prototype-MapClamp ordered
- aaronneons map clamp- 1st step problem
- Tuning Powerpaq map clamp setting
- Map Clamp not working correct with the emanage?
- Tach adapter question
- Friend needs help with UTEC for his WRX
- what do you think of this
- Going to be tuning the emanage Thursday (08/12), need some hints...
- VC2 vs OTHER clamps
- Greddy Profec E-01
- new emanage install, have ?s
- Help with Blitz SBC!!! (Monitering Voltage)
- Stand Alone???
- How to properly tune a map clamp
- Greddy e-01 Map sensor Voltage Conversion chart??? help!
- problem with emanage
- Need Help Asap!!!!!!!!!!!!! Stat!!!!!! Please!!!!!!!!!
- Stock Vacuum Harness Diagram
- a/f guage install??????????
- AFCII - idle fuel control
- please help me how ever you can... APEX~I AVC-R
- Map clamp values = ?
- Track Tuning
- Good Data Loggers
- EE's, can one of you peeps design an analog signal switch?
- Stock O2 and programming stock PCM
- afc sensor
- E-manage
- SAFC Knock Settings and Counts!!!!!
- Is anybody using this OBD2 diagnostic? Can we?
- Profec E-01 install help
- Ecu
- Tuning my map clamp
- Going off the deep end, glub, glub!!!
- getting my t3/t4 50trim soon, tuning Questions inside...
- Stg1 INJ's on a stg0 03
- MAP sensor???
- Why is everyone using SAFCs??????
- Looking for SAFC II "insight"
- Need help "stuck" with S-AFC 2??? ASAP!!
- LM-1 rpm cable prgramming question
- Profec e-01 and emanage reprograming?
- anyone play w/ S2 and s-afc to lean it out some?
- Installed the DynoJet Wideband Commander
- afc
- Wide Band O2 Wiring ... Bosch LSU4.2
- Differences between safc II, and emanage?
- Please Help!!!!
- PLX Devices M-300, anyone using it?
- stopping the o2 codes (O2 sensor simulators)
- Haved some money to spend. Which would you get
- WATER/ALKY Inj DYNO #s ARE IN!
- Can s2 injectors, a emanage, and a map clamp give me alot more power
- Aftermarket o2 Sensor? Install and Brand of product?
- E-Manage Discussion/Help Thread
- where is the tach wire?
- profec b spec II
- tach adapter part# 8912
- Can (iso15765/sae J2480)
- Problem with Emanage Help!
- PowerPak display question
- aaronneon map clamp
- Dyno'ed SRT: 270whp 345wtq
- Stumbled on a WEIRD injector hack...
- Piggyback preferance?
- What do I need to get? Please Help
- A/F Ratio at mid-throttle question...
- SAFC help please
- which wideband??
- Can the SAFC II Sensor check feature be used to tune/adjust a map clamp???
- E-manage and Ignition Controll
- Technical: The Lowly Oxygen Sensor
- 10K Potentiometer for Map Clamp
- Acouple questions that need your opinion....
- Latest version of PowerPaq and some Q's
- What Is A Good Voltage To Set A Map Clamp At...??
- E-manage questions
- Hooking up e-manage, have some questions
- power paq and pcm question.
- Datalogging TIMING?
- How to test gauges b/f install?
- YES OR NO? safc II with map clamp????...
- Anybody use a map clamp w/ S2 to try to make it run less rich???
- (Exhaust Depot) Hector's Emanage results are impressive
- Profec B problem/question...?
- 3bar map and tip sensor for stage 1.
- e-01 setup help needed!
- Pyrometer/ LM-1 Wideband Tuning...Must read!!!!!
- PPAQ Problems!
- Another map clamp question
- How to bench test WGA's?
- Stage 2 MAP voltages....Chart by Psi-Fi
- does anybody have a really good map for the pp???
- PROBLEM with my profec b!??
- does s2 pull alot of timing past 20psi???
- Gasket Question!!??!??!?
- Will 250lph fp, RC injectors, safc, and map clamp...
- Hydra...
- Any Tuners in the Pacific NW area?
- need a little advice on tt install
- Circuit Breaker.
- Apex~i SAFC (II) Discussion/Help Thread
- need help wireing in hi6-di2
- Anyone making ~350whp post setups here
- Stock Turbo and Cam Specs...
- Harness for a Turbo Timer?
- Greddy Profec B Spec II Questions
- Profec E setup...thoughts and opinions...
- Going to use Water/Alc Injection, any input?
- Avc-r installed
- S2 W/ Profec Spec II settings?
- Need some quick advice on Fuel management
- HELP--AVC-R Install
- Apexi AVC-R Electronic Boost Controller
- Ways to tweak a/f
- Questions: Tuning/setups/troubleshooting
- T3/T4 and Stage II tech help!!! Tweaker! Step in!
- Knock
- S-AFC II Question
- Pulling timing?
- Does S-AFC work or not work on our car's?
- Need help with AVC-R
- Help!!
- I need ECU wiring diagram
- Nitrous "WET"
- Autometer Air/Fuel Gauge Installation...
- Stock POS IC
- Tuning the ECU
- 255 fuel pump part number
- Air Flow
- Need Help
- need factory vacuum harness.....
- Profec E-01
- Throwing it out the window
- Oil Pressure Specs....
- Power Paq Power?
- stand alone engine?
- Anyone use Propylene Oxide
- #1 o2 sensor- 0-1V O2 sensor
- 3" Downpipe with high flow cat ?
- Question on installing nitrous wet system, where to pull the fuel
- Looking for help installing my EBC
- Power Paq Baro Read question?
- emanage guru's
- Ebc ?
- Decisios, Decisions...
- Apexi SAFC (?)
- Dyno somewhat confused me....
- E0-1 question
- TXS Fuel Cut Question
- Anyone looking at hacking the stock PCM?
- S-afcII....limitations...
- those with Psi-fi powerpaq...
- Whats out there for computer tuning
- Air Temp Sensor
- Someone help me find out why my car is so slow..
- The secrets behind today's faster engines by Jim Kerr
- The secrets of bolt tightening by Jim Kerr
- Best Stand alone & why
- Fuel management? Suggestions
- Need Help Asap a/f meter
- A little info on Race Gas
- Dyno data for my car (confusing)
- Knock Sensor
- air to fuel ratio
- SFAC wiring diagram?
- Map discussion. stage 0 and stage 1
- Swapping PCM's
- what kind of piggy back system should i run?
- Psi-Fi PowerPaq Discussion/Help thread
- Gear dependant EBC/MBC.Steer me in the right direction.
- stage one and boost.
- Setting up the greddy.
- Post your EGT readings.
- anyone know the
- Dyno tune with E-Mange? What Clamp setting is best?
- Apex-I controller
- want nitrous but dont know what jets here is how :)
- hks evc vs apexi ebc?
- Who has info on the crank trigger/timing wheel?
- tuning gurus wanted
- PwerPaq ~vs~ E-manage
- big power gains with PSI-FI piggy back ECU
- Ordered a Wideband O2 today ...
- Wiring up A/F Meter w/ new 02 Sensor...(help)
- Electromagnetic Bearing for Turbo
- reseting ECU runs rich closed loop
- innovates air/ fuel meter,$350
- tach signal
- chistmas gift fuel computer upgrade
- available to us?
- initial observations with wideband
- need your help with this
- MAP Voltage Table
- Hks Evc
- Voltage Clamp install question
- black box???
- S-AFC and bigger turbo????
- Boost ant Fuel Controller
- What really is the benifit of Stage 1(discussion)
- greddy profec b 11
- HELP,Stock boost gauge VS Greddys...
- Clamp people, A code question
- time to buy .......Piggybacks