PDA

View Full Version : Technical Tuning & EFI/EMS Electronics


Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 [19] 20 21 22 23



  1. Clamping The Knock Sensor
  2. Timing Tuning Device?
  3. IAT help
  4. Getting an 04 PCM to work in an 05
  5. high tech in car tuning with in-dash TV.
  6. Help!!!
  7. Is my car pulling timing or what?
  8. S1 or S0 PCM?
  9. how much boost? (not the normal question)
  10. non profec e-01
  11. stage 0 > stage 1
  12. greddy e-manage ultimate
  13. Quick SAFC II Question
  14. 60-2 wheel and aem?
  15. SAFC prs./boost dont match up with boost gauge
  16. Emanage Question
  17. EDs Emanage kit? or Apexi S AFC II and AFR wideband?
  18. Need help with S0
  19. Emanage Injector Correction
  20. God doesnt want me making 400hp
  21. *** E-Manage users: Look Inside ***
  22. Any piggys add fuel?
  23. Datalogging Timing
  24. Fuel management/Boost control
  25. Opinions...Desensitizing the knock sensor w/teflon tape, good or bad?
  26. power paq -vs- SMT-6
  27. LM-1 Log Works 2.0 Beta Here!
  28. AEM eugo o2 sensor gone bad??
  29. emanage or injectors
  30. Emanage: Injector Correction - Stage 2 Inj. on Stage 0
  31. FUEL PUMP VOLTAGE BOOSTER (Due in 2 weeks)
  32. wires left over after SAFC install
  33. Will this cause PTB
  34. V-AFC Question?
  35. From S2 & safc to S0 pcm, S2 injectors and safc...Now p0129 & P1187!!!
  36. post where you mounted your tach driver
  37. emanage maps
  38. going lean at 2000 rpms only-safc installed
  39. Greddy E-01 or Apexi S-AFC
  40. How does this sound?
  41. map-clamp tune...how much of a turn?
  42. Stupid question regarding spark plugs.
  43. Installing A/F gauge???
  44. EFI Systems Inc. UEGO 1000 Anyone seen this wideband before?
  45. best datalogger?
  46. Advantages of useing SAFC and MAP clamp together
  47. To Much PTB Bad?
  48. What is the TPS voltage range?
  49. The $199 WIDEBAND, displayed on your laptop...
  50. Apex'i Turbo Timer and Air Fuel Option
  51. Problem with my LM-1
  52. fixing an idle with emange
  53. DTEC Discussion/Help Thread
  54. DEFI a/f Gauge : Input needed
  55. about the hesitation at low rpm's
  56. AEM UEGO vs. ZEITRONIX WIDEBAND?
  57. Tuning afc at idle
  58. Ignition Tuning: 3 Bar MAP on Stage I
  59. Just tuned car using safc2
  60. Dyno Tune V.s. Wideband...which First????!!!!
  61. Still Sputtering!
  62. My car sucks need help with mapclamp problem
  63. tuning
  64. eManage Ultimate Support Tool
  65. Profec E-01 signal harness wires
  66. TIP ... PSI vs Voltage ... Same as MAP?
  67. Volt Meter?
  68. Digital Progressive Map Clamp, Plug And Play Unit
  69. safc2 and fpr help
  70. help with safc!
  71. Anyone have an off the shelf Emanage that can check something for me?
  72. ignition diagrams?
  73. Map Clamp ?
  74. Any ideas on what this problem sounds like ?
  75. More Confused
  76. Has anybody had problems with E-01 and Zietronix WB?
  77. AEM wideband O2??
  78. Just got back from dyno
  79. Casper Knock Guage or Similar?
  80. Did I get the right product?
  81. Datalogging w/ PDA
  82. question on D-TEC
  83. Partial Stage 2 Upgrade
  84. Dtec users, in here please........
  85. MAP Mod .. Input needed .. What ya think?
  86. Regarding SAFC2 RPM
  87. SAFC help: #4 in the ECT. Menu
  88. EGT's?
  89. ? with safc
  90. need some help with tune
  91. Need some of the guru's help
  92. What should my A/F Ratios Be??????
  93. Knock sensor wire on SAFCII, help
  94. Interesting discovery, street tune vs. a dyno tune
  95. cutting out after install
  96. quick SAFC2 question...
  97. Power tuner
  98. To Tip or not to Tip.
  99. emanage blue+wideband o2= best map clamp EVER!!
  100. PowerPaq Question
  101. Whats the Best...e-manage, Map Clamp, etc
  102. Injector Code/Limp mode woes
  103. Received e-manage today
  104. additional injector map HELP!!!!
  105. Help with ZT-2 wideband PLEASE!
  106. The benefits of a stand alone ECU in a piggyback one!!
  107. Where to Mount E-01 Display?
  108. where is a good source for a ignition hot wire
  109. I've had it with this car!
  110. safc good or bad?
  111. would a regular A/F guage work if...
  112. emanage gold....
  113. Hooking up wideband to emanage without e01
  114. Cheap Wideband for those using emanage, or device with afr display
  115. have afc low setting question s2 injectors/aaron's line
  116. Need help from anyone that may have experience....
  117. which wideband to go with?
  118. EGT 1600F+, A/F Log, Tuners any info
  119. SAFC-II does it need the msd tach driver?
  120. boost going crazy after map clamp
  121. can any one tell me? SAFC question.
  122. LM-1 v2.0 Calcs HP and Trq
  123. Codes after AFC install - map voltage low
  124. Map Clamp supporting mod?
  125. New guy here... Need info on stand alones
  126. SAFC II- Lets talk Timing!?
  127. APEXi AVC-R on an 03 with STG 1
  128. Safest place to clamp lower
  129. im new . im sorry but
  130. map clamped at 3.85v with greddy pressure sensor
  131. Can codes effect Eo1/emanage? Please help!!
  132. yet anothere safc-ll Q's
  133. E-manage and UEGO question
  134. YAY, another afc question
  135. need safc-ll help baddly
  136. need fuel help - SAFC II
  137. 12.5 a/f safe?
  138. AEM EUGO o2 sensor location
  139. To powerpaq or not to powerpaq
  140. Has anyone else tried this?
  141. map clamp w/ safc ?'s
  142. Has anyone Datalogged with AEM Uego?
  143. What the F is a map clamp
  144. Is there a balance between map clamp and stand alone EMS for A/F
  145. Have Good Power Paq Map?
  146. Timing being pulled???
  147. boost til 15psi then it feels like it shuts down? - SAFCII Tuning help
  148. SAFC w/MAP questions
  149. Dyno tune vs. Street Tune
  150. Can I claim to be the first running ignition on emanage?
  151. SAFC I Settings?
  152. Older AEM Uego cant read below 11.0???
  153. a/f ratios
  154. Dasmopar map clamp tuning
  155. is it that easy, to tune with SAFC?
  156. AFC's grey wire!
  157. What is megasquirt?
  158. Question about SAFC II
  159. afc2 how to
  160. Air/Fuel Ratio Gauge
  161. AEM EMS info
  162. Aem
  163. Psi Fi Unit
  164. Factory PCM for SRT4 or PTTurbo.
  165. wiring diagram for super afc controller?
  166. (newbie)management question
  167. PPAQ mounting
  168. Das mopar Map clamp??
  169. Exhaust Gas Temp ??'s
  170. Bad stumble under load
  171. Stage 2 map sensor voltage at idle?
  172. wiring help for e-manage!!!
  173. Q:Turbo Timer
  174. Psi-Fi w/ Stage 2
  175. Car acting funny under 3000 rpm's
  176. a/f ratios with stage2 & map clamp
  177. Megasquirt
  178. Open-source engine tuning hardware development
  179. Sorry in advance fer the n00b post here :) .. pls read when ya want a chuckle
  180. simple question about W/I and high tech tuning
  181. time to let out my frustration on customers stage 2 car
  182. how would I control WI, with my emanage/E01???
  183. stage 0 ecm discovery!!
  184. anyone with a aem uego have this problem?
  185. a/f ratios
  186. simple question: Can you data log off of AEM Wideband gauge?
  187. Stage 2 Emanage users
  188. AFC Install throwing a code!
  189. Stage 2 DAB and MAP clamp?
  190. What combo would you choose?
  191. base maps or just maps................ definition is ?
  192. AEM EMS Universal and stock harness
  193. Stand Alone Help PLEASE!
  194. My emanage is controlling the ignition but...
  195. S-afc I
  196. tip mod with stage2 & map clamp
  197. just a simple question about innovative
  198. TIP Sensor Talk
  199. S-afc Ii
  200. Experiments with S2 injectors...
  201. e-01 harness confirmation
  202. Need advice on fuel management setup Badly
  203. SMT-6 users
  204. i hate it
  205. Am I really out of fuel?
  206. My E-01 screen reads Error...Any1 know what this means?
  207. Every1 with s0 ecu and rc650s/750s please read
  208. "Emanage and aftermkarket BOV users, you're gonna want to read this"
  209. stage 0,1 or 2 pcm with big turbo kit
  210. Is it true tuning gets screwy when boost is lowered??
  211. Why E-01?
  212. Weird boost controller problem
  213. Bought used emanage...doesnt have CD-ROm
  214. Setting Map Clamp
  215. well we did it now we need you to help - Hydra EMS PnP
  216. Emanage limits
  217. map sensor greddy 3 bar pressure sensor
  218. How harmful can knocking be?
  219. Innovative Wideband?
  220. Safc2 - good afr's in 3rd, to pig rich in 4th?
  221. Emanage RPM ?
  222. who knows there EGT today????? DO YOU?
  223. emanage/e01 problem helpp
  224. emanage + signal 11 :(
  225. E-01/Emanage map clamp questions:
  226. S-afc2 dumb questions plz simplify :>
  227. zietronix wiring info??
  228. Help me get my LM-1 wideband reading right on my e-01:
  229. Please help S-AFC always running too rich or too lean.
  230. Can the car still pull timing if it has an safc-ii
  231. TRAXMAN Emanage Tuning Tips
  232. Ed E-manage
  233. 180 degree stat PM I wrote.
  234. AGP 50trim running Emanage: Need some help!
  235. 256.9hp and 313.9 torque - Tuning the Map clamp
  236. PSI FI PPQ / Mac
  237. veterans what is a good air/fuel. please help
  238. S2 3 bar MAP volts?
  239. Didnt break 400hp but close
  240. Greddy E-manage vs. Apexi SAFCII?? simple question
  241. looking for good tuners in wisconsin or chicago area!
  242. ED Emanage Units Everything you wanted to know.
  243. How to display stuff on E-01?
  244. Will not having a good throttle reading(from MAP) with a S-AFC cause me to run lean?
  245. a ? after install, SAFC II
  246. Emanage Support Tool Cable Schematics
  247. 378hp/385ft. lbs @ 24psi, good?
  248. Map clamp 4th gear boost problem
  249. map clamp/emanage timing
  250. Greddy Profec II folks, need an answer.

Search Engine Optimization by vBSEO 3.1.0