- Anyone familiar with e manage please answer this.
- AEM UEGO Wideband Issue....help?
- Zeitronix Pocketlogger Software
- Help Please truble with E-01
- stage2 with stage1 injectors
- tuning a stock pcm?
- Safc Ii
- Pro Tuners, I need help
- anyone ever seen this chip?????
- Zeitronix Boost Sensor Help
- Help!!
- Emahage question. Changed one thing and now car run lean as hell.
- Mopar Gauge good enough for tuning?
- Just installed the new fuel tunning module.
- wideband sensor going bad (question, not on my car)
- Mapclamp tuning...
- How do I measure my timing?
- 750 fuel question and SAFC. Car not running
- MDS Tach Adapter
- What harnesses do I need for Emanage?
- Why doesn't the Rev Warning work on my SAFCII??
- Apexi Power FC Commander anyone???
- AEM wideband install help
- My timing with data logger
- Setting Map Clamp with E-01
- Reading 3-BAR MAP voltage?
- Innovative LC-1 reading 00000
- S-AFC Tach signal problem.......
- Mapclamp didnt work..Help..
- Need help w/ E-01 Emanage Cash $
- Weird Emanage/E-01 Problem....
- Apexi AVC-r
- A/F Gauge.....no bashing
- map clamp
- Does weather effect tune?
- mapclamp without a wideband.
- OBDII Scangauge (52mm gauge), displays timing, intake temp, etc...
- resistor value please
- safc 1
- Extra injector controller ...
- what to expect? tuning SAFC and Map clamp
- Fuel/wideband question
- High Tech tuners Help!
- AF range on stock O2 sensor
- What sensor is intake temp on OBD scanner
- safc settings help
- SAFC 1 or SAFC 2 ??
- Has anyone heard?
- map clamp and spring mod
- a problem with safc II and map sensor
- BS Removal + HOM Mode??
- Air/Fuel Gauge install Help
- Road to 400 on pump gas
- stage 0 big turbo - getting rid of fuel cut
- Aem's Ems?
- Need help with psi fi power paq
- AEM"S EMS?
- HELP! What is the RPM wire on MSD 8912?
- PTB & Return line
- MotoMan’s engine break-in tips
- Map clamp and Apex safc
- any one else
- Zeitronix Data Logging
- SAFCII questions
- When Turning the SAFCII
- Dont have the $ for a A/F wideband...is this a viable alternative?
- question for those in the know
- emanage with laptop help
- More boost=lower air fuel ratios???
- Where to start...
- tuning question
- 3" exhaust=air fuel questions
- safc2 q's
- S3 ECU with Stock Turbo for pro race series?
- question about ptb
- 750cc inj/walbro pump with just map clamp
- JET Chip and custom tuning?
- whats the best eman firmware rev to use?
- innovate wideband please help
- Need Some Help To Tune My Srt With Map Clamp
- How difficult is Emanage to learn?
- to any one
- Problems: Emanage or Stage 1 ECU????????
- Using AIT to adjust timing and not fuel?
- Aem Ems
- Old School Apexi AFC?
- 2nd Gear a/f ratios
- Bov Help
- Interesting ...
- Which ECU Do I Have??????????
- Which Item should I get first?
- a/fs ok?
- DTEC knock light mount
- do i need to be happy or sad?
- INFO/HELP??? Please
- engine stumbles at ~2800 rpms...what to do??
- dyno tailpipe sniffer accuracy
- 05 tuning is a nightmare.
- DTEC or SAFC
- Newbie Datalogging
- New 50 Trim numbers
- Remote tuning of piggy backs and standalones
- safc 2 tuning
- Ideal A/F Ratio?
- Engine Dies at 20.1 PSI Help????
- here's a map clamp question you DON'T see everyday.
- Adam at Spankin Time Motor Sports
- stand alone system
- S2. It Figures!!!!!!
- if you were to mount a trigger wheel
- DTEC failed to load...any ideas?
- Hey S2 guys question to ask you..
- Has anybody installed the New DTEC FC/BC Combo yet????
- having problems with my DTEC.
- wiring for safcll
- Greddy Profec E-01
- Datalogging with Zeitronix
- emanage error 23:0387 ????????
- Fuel & Spark Cut... When does it happen?
- whats the best ecu to use
- What does a map clamp do?
- Anyone who's dynoed with ONLY Stage 1, what was the a/f ratio?
- MSD DIS-2 users, a question for you...
- Das mopar map clamp help.
- AEM Wideband ?
- Removing Rev Limiter
- Turbo XS Utec Controller
- no idle
- S1 + map clamp = how's the driveability?
- Using LC-1 Wideband to simulate existing O2 sensor
- whats the deal with my hp numbers??
- Somebody HELP ME E-01 settings
- First Gen ATX Computer Upgrade
- ECU hack*
- SAFC controlling boost? (S2 w/ toys)
- A/F Gauge And Wideband run on same o2sensor?
- S-AFC II vs S-AFC ???
- Will I need SAFC?
- SAFC tuning?
- Question for Das Motorsports...
- How much timing is too much timing
- Dasmopar map clamp opinions
- 02 Sensor...?
- Our Stand Alone Needs Might not be as needed as you think
- software diagramming tool
- Confused...Mapclamp afr
- 2005 SRT-4 PCM Wiring Diagrams Available!!!!!
- knock reading on SAFC
- Tuning?
- timing help
- trigger wheel
- 2005 SRT ECU PIN Layout
- Stage 2 vs. Stage 1 Timing Issues
- Map clamp S2 W/O toys 100 octane
- I need a datalogger
- Dynoed 300 Whp Stock?!?!?!
- no dynos, tune on the street?
- Aem Ems MIA?
- Aem Wideband
- anyone running this wideband
- safc
- More DTEC Probs....
- DTEC help
- about to get a DTEC
- About fet up with DTEC....
- Greddy Profec E-O1 Install
- HKS super afr
- need a good tuner arond east tn
- Help !!!!!
- fuel setup with SAFC II
- safc2 base map
- Fuel Injectors???
- SAFC2 wireing question
- 03 vs. 04 ECU
- In car dyno...
- Dtec Tuning Help
- Stage 2 alternate TIP/MAP sensors?
- safc set up
- safc II
- safc2 or stage 3 fuel rail
- Using SAFC with Map Clamp?
- p0108
- First dyno on 50 trim
- DTEC NO RPM Signal
- here are my safc2 settings there way off help wanted
- LM-1 Question???
- Going to be installing a fuel return setup Saturday..
- weird question
- Question: O2 sensor placement and tuning
- chill factory turbo kit? what to use for tuning?
- emanage or safc or safc2 too tune a 04 sxt turbocharged?
- Do what now? How to Learn about tuning?
- safc help
- GT40 owners please come inside and help? some tuning questions
- SAFC-II tunning question.
- SRT Engineers will answer any question!
- Need switched ignition power source
- ECU connector Part number...
- Apexi TT (AFR) HELP
- VERY IMPORTANT dtec question!
- Another tuning idea....
- My A/f ratios
- Question on LM-1
- Dtec and gameboy micro
- Tuning the Apexi SAFC II
- NEW mod!
- stage 2 w/o toys and safc2
- Turbo XS FC/BC
- Stage 2 map voltage, quick question
- a/f ???
- using data logger to read a/f
- DTEC Tuning Advice
- Open loop
- A/f gauge or EGT gauge??
- Cheapest way to tune a map clamp?
- DTEC fuel question??
- TurboXS HPBC question - need your help!
- Problems with map sensor voltage need help
- safc2 and lean on the top
- Help with OBD2 Datalogger...
- Safc Ii
- Is there a topic on this?
- Where to get e-manage software?
- The Hydra ems FAQ
- How do I zero out an Emanage?
- Txs wide band question...
- P0112....????
- PCM part #'s
- The OFFICIAL "stumbling and studders at part throttle with big turbos" THREAD
- Car falls on its face between 2400-2600rpms...Stumped!!
- Tuning question for mapclamp........
- MSD TACH DRIVER question
- E-01 + PLX m-300
- clamp, Meth injection, Hom.....!?!?!?!
- SAFC 2 wire cutting question?
- Big turbo installed car idles at 12:1 a/f with emanage help!
- laptop progams
- piggy back's wich one is best?
- Lma-3 Aux Box
- please help 33psi
- AFR help
- 50 Trim/Safc help
- TPS Sensor
- can you use msd pn8912 as tach adaptor?
- Good power, but very odd chart
- help, WOT shifts into 3rd and 4th power fall off - Timing?
- 521 WHP need help
- Map Clamp
- Presetting MAP clamp voltage
- Will weather affect the tune of a mapclamp?