- s2 pulling time question!!!
- Egt
- Car faster with A/Fs in the 10s?
- PLX iMFD Gauges
- please help fuel/spark problems
- Stage 3 timing (right?)
- Apexi AFC nom
- Need advice on Tuning
- tuning woes
- Apexi V-AFC
- Tuning at 58PSI or Boost referenced 40PSI
- Car running like crap! help please..
- Knock and Tuning
- PCM Question
- tuning
- Big turbo + Scan Gauge or Tech gauge PLEASE read
- Input on new Apexi AFC NEO
- 50 trim, 22 psi, and HOM?? Bomb..or safe?
- s2 w/o toys DAS MAPCLAMP VOLTAGE
- datalogging a lc-1
- PLX Wideband (Any Vendors?)
- Advanced numbers-are these good?
- Upping the Boost
- Chart for map sensor voltage's
- e-01 help!
- Which PCM?
- wideband discussion
- stg 2 timing
- Tuning to start with
- Is there difference in 3rd gear pull and 4th gear pull
- data logging program
- safc2 setting for stage 2??
- emanage question (red light)
- AEM UEGO just installed...got some questions
- Help with SAFC
- what voltage to clamp s3r?
- Timing issues, Please help
- AFC question
- booost vs timing with some data
- wideband with E01
- Sorry to butt in but...
- AEM EMS Questions
- DTEC no rpm signal??
- Afc Neo
- map and tip sensors???
- DTEC vs SAFC2
- air/fuel ratio gauge
- i need rpm signal help
- Map clamp?
- Whats your knock reading on your Tech gauge?
- Tuning Help: Dtec + S1 + S2 Injectors
- Boost rising and falling HELP!!
- Please HELP!!! Massive Horsepower Loss. Turbo, Timing,
- knock retard
- Dyno dynamics .VS. Dynojet
- Tach Driver needed? timing pulled?
- another e manage question
- Aem Wb Vs: Egt ???
- I need a base map for the Dtec.
- "normal" Intake Air Temps?
- 682cc + 3bar tip + wga + tune = stage 2?
- Aem Wideband + E-01
- Wats the safest Boost i can run with 93 oct on a GT40.
- p0172 - Too much fuel, tuning?
- AFR Question.
- label map sensor wires ?
- Adjusting the voltage on a map clamp
- J & S Safeguard
- Stock o2 sensor output ?
- DBB 50 trim + Safc II + S2 = big shit !!!
- How much fuel are you pullingw/DTEC on big turbos
- Power difference with A/F Ratios?
- how to get RPM signal
- Dtec Install - Orange and Black PCM plug??
- plx r-300 questions
- Suggetions for a data logger and tuner
- Map Clamp ?
- Too rich a bad thing?
- question on tuning and a/f
- Video of data logging on PowerPaq - See anything wrong?
- LC-1 Wideband -- Anyone using output to drive ECU ?
- HELP, PCM and Turbo Toys
- aem uego
- Innovate Motorsports RPM Converter Hookup
- help please...
- lc1 questions
- where to install wideband O2 sensor...
- best wideband
- Help Guys!! Snap, Crackle, pop.. Tuning?
- How Much Are You Pulling? SAFCII
- Safc Neo
- Map Clamp tuning..........
- AEM Wideband install question....
- Ptp 75psi Mod Vs. S2 Injectors
- Leaded gas and widebands
- aem boost solenoid or dual stage BC
- 750's to big for 3147?
- help on tunning safcII
- TXS tunerbox mounting spots...
- aem wideband and emaangewith e01
- HELP: After SAFC II Install car wont start..
- Afr questions about my readings on uego gauge
- Basic tunning questions
- Dtec quick question
- So worry right now please help or advise!!!
- Base AFR Map
- where do ya mount yer ngk afx wb?
- Good place to start w/ map clamp
- need a base map puleeezzee
- wiring harness
- Use your AEM logger as a dyno
- AFR :rich but sputtering a little bit?
- Tuning
- MAP clamp compatable with DAB?
- Confused about wideband readings
- datalogging
- Too Lean for low boost?
- Dtec Ordered - Planning on 3 maps!! ??
- Stock Turbo Dyno 302 hp and 375 ft lbs
- tach adapter question?
- Wideband upgrade, or add-on?
- safc help
- PTP FTM Reviews
- lc-1 connect to dtec
- Going way lean
- Need some guidance
- Closed Loop --> Open Loop Switch Over Point?
- emanage software
- Damn P0107. Need some help.
- LM-1 Wideband install question
- tuning problem
- HELP reinstalled S0 PCM and now have error codes
- New and improved Coil Dwell setting for AEM EMS
- Help please...D-tec question
- Need help installing lc-1
- injector harness
- Wideband datalogging questions...Innovate
- Greddy E-manage Ultimate on 420A setup
- AFR Narrowband
- Anyone know where to find E-01 Harness #15900543
- What is out there?
- any aem ems brake throughs?
- permanent wideband wire entry point
- question about placement of o2 sensor
- SAFCII Question/help needed please!!
- map clamp question
- S1 question ? Not sure if im in the right thread.....
- fuel pressure help..
- Stage 1 with stage 2 3 bar map/tip
- Need safc base map big turbo
- Tips For Tuning Both Pump & Race Gas?
- o2 sensor question plx m-300
- Dyno Tuning?
- help on safc or map clamp
- good standalone
- still tryin to find out that perfect airfuel
- using an lm-1 with a greddy e-01
- Cars Running Like poop, tuning? rich?
- Map clamp question
- Tune????
- Post your emanage settings here
- General tuning fixes for Stage1 issues
- Dealer Locked PCM! HELP!!!!
- SAFC II, MAP Clamp and ACV-R Questions
- Help me With my Psi fi power paq PLEASE!!!
- AIM Digital Dash/logger for AEM cars
- E-manage acceleration map???
- safc help
- having trouble with my safc reading the rpms to low ???
- need some help safc
- NGK AFX wiring trouble.
- Mapclamp tuning help
- detonation help.
- e-manage not clamping? tuners help.
- Help with DTEC BC
- Stupid DTEC ?
- p0172 effecting WOT?
- ElmScan ISO Diagnostic Scan Tool Package (OBD2)
- Problems with e-01
- dyno flash
- Dtec install ?'s
- dyno tuning?
- 04 srt4 gear ratios?
- Help fast please! need DTEC map
- Need help Bad... Srt-4 Is acting weird
- Resistor Box, How do you make one.
- basic assistance needed
- Solid Mounts and Low Timing in conjunction?
- New AEM projects from RRev Motorsports
- Srt A/F gauge From Mopar SuperCenter
- Has Anyone installed...Apexi afc neo
- Engine Timing?
- S-afc2
- Need some tuning help?
- AOBE help on a 98 SRT
- SAFC...need help how to put percentages in hi/low throttle...
- Any thoughts on getting a stage 2 flashed to stage 3
- FPR 75psi, Dasmopar Mapclamp, voltage?
- Dtec map help(for me too)
- CTS and IAT's role in calibration
- need dtec base map
- Tuning with Staged ECU only
- All of a sudden.....
- Big turbos, boost and octane (When to run race gas??)
- Dtec Fcbc Help Please!
- How many would like a fix for PTB and the CEL on the 05's.
- NGK AFX Wideband ????
- EVO type reflash on SRT-4 PCM?
- UEGO Problems Help!
- PCM reflash runaround
- venom 400???
- Whoever has a DTEC help me
- info on HOM and S2, via tech-guage.
- eManage help please!!!!
- E-manage clarification
- DTEC Question??
- ? = timing being pulled
- need help with fuel cut
- Dtecfcbc tuner problem?Help?
- To those who put their UEGO in their stock gauge pod
- Anyone have tryied this ?
- AEM EUGO readings
- Safc 2 TUNING questions... .50 Trim'ers
- AEM EMS Screenshots?
- Looking for a great Wideband???
- which wideband is best with dtec
- LC-1 and LogWorks 2.2 --- log files
- Looking for a good wideband
- Lower RPM Bogging
- a/f guage
- help.. fast.. emanage
- Need aem wideband 02 sensor
- Need help lowering knock
- Stage 0 and rich???
- powerpaq diagram
- Dyno extremely rich!!!!!
- Relocating PCM.
- SAFC Tuning advice...maps, presets?
- Fuel trim and WOT
- Afc Neo
- A/F Ratio Spiking at 7:1 HELP
- tuning mapclamp
- where to buy ngk afx replacement sensor
- stage II w/toys tuning?.........
- Stupid DTEC Question....
- A/F Gauge stuck on rich
- SAFC II and Wideband
- Help PLEASE need wiring info for TIP sensor
- HELP! My car falling flat at high rpm's on Dyno with Nitrous??
- any1 tuned the dtec fc/bc w/ gt3076r?