- Just ordered AGP 3147, any Maps for PPQ?
- intake rubbing cam position sensor
- Just ordered 50-trim
- any update on the new turbos
- Got the 3147 but have ?
- nice
- Race FMC Worth the wait.
- AGP Please Read ASAP!!
- Agp wga Nightmare
- How do i preload the AGP WGA???
- AGP SAFC fuel kit
- 3147 Q?
- can some1 call me, fc/bc question
- Dtec wet wire need help
- Tubular Manifolds
- 50 Trim Break in Question
- Closing Early Friday 4/14/06
- Agp WGA rod replacement Help?Please ASAP.
- question about GT3076R
- What about the eagle rods
- "too" much out of the SAFC?
- do you sell exhauts gaskets?
- What's going on with my race cooler?
- Just got my 3" Turboback!!!!!!!!!!!
- Wuestion about weisco pistons
- dump tube
- just ordered 50 trim and 3" intake.
- attn: jon
- Hrm, what is this? AEM EMS
- MM and TM installed but Odd Noise
- My turbo upgrade price?
- Just the upper mount...
- "omg Run! Its Lagzilla!!!"
- Am I getting some timing pulled
- WGA Question
- CAI causing coolant leak..any ideas???
- i wish i had a camera here right now
- Intake Question
- Got the 50 trim
- My AGP Stage 3R WGA
- installed UHP great product
- Motor Mount Help
- How are the race coolers comin along?
- FPR Question
- Dtec-FCBC help!!
- Agp S3r Wga ?
- Resistor for AGP UHP
- question
- Return line fitting
- Turbonetics Wastegate
- return line and boomba
- Agp Wga
- spool turbo question
- Bleeder valve question
- Installed MM's and Tranny Mount.... New Odd Noise
- Race fmic rated at 950hp by Garrett?
- Uhp, Lhp?
- In stock?
- Agp Uhp
- Tuner Wideband Q?
- FMIC questions
- race fmic status
- New cold side pipe AIT sensor with?'s
- Props to AGP and their great customer support
- AGP turbo kit "Evolution Waste Gate" and turbo xs dual boost controller how to hook?
- Can I use the AGP wga on S2 toys without issues?
- Another AGP powered SRT-4 breaks into the 11s
- only 16 psi.....
- quick question
- Order Question
- New SRT-4 ACT Clutch and Flywheel Kit, NEW PRODUCT RELEASE!!!
- Motor mount problem.
- Do you have a pretuned map for .50 trim with no return line?
- stage2 and vac lines with 50 trim
- Ben or Nick (Order Info)???
- Stage 2 toys now..what AGP path would work??
- turbo/manifold gasket?
- Turbo kit fuel later?
- Computer Question
- Solid Engine Mount Repair Kit
- Cast Manifolds, Come and Get 'Em!
- Polished Intakes, IN STOCK READY TO SHIP!
- Wastegate Reroute Kits, THE QUIET MOD!
- Sent Out Payment Today
- 50 trim vs GT3076R
- Verification\Simple question
- Question about your manifold
- Final Pump Gas Tune GT40 stock internal motor
- wastegate to turbo compressor????? problem???
- dtec fc questions
- Still waiting for HARDPIPES?
- General question about WGA
- 3147 ???'s
- few questions
- DTEC install question
- 50 Trim fuel question
- ?? Just bought the B&B turboback ??
- which compressor cover?
- Jon I tried to call back..
- Small AGP Direct-Fit FMIC Problemo...
- turbo question??
- Jon:
- Max/Safe boost for stage 4?
- AGP Powered beast soon to be finished.
- stg4 w/o intercooler?
- Idiot question about AGP wastegate
- Hating D Tec right now....
- TODAY I DYNO 50 trim
- agp stage 4
- 3147 Turbos, back in stock!!!
- Running Stage 2 with 50 trim
- Problem with website
- Intercooler backorder
- Shift Selectors, BACK IN STOCK!!
- AGP cats (Lucille lingo), please input on this thread (linked)
- Strange WGA Boost Problem.
- Quick Question !! Help!
- Turbo selection???
- Need a base map please
- Stage 4....now what?
- can you help?
- HP54 Turbo?
- AGP can you help me size this turbo
- thanks to everyone at AGP!!!!
- noob question on WGA
- hey guys
- Need price on 1 busshing and 2 washers for AGP dog bone mounts
- help... dammit
- turbo ?
- AGP FMIC best price ?
- tranny mounts
- want to buy D-tec fuel kit
- Safcii
- fuel return kit, problem advise please
- 50 Trim Spooling Problem!!
- Agp Do you know if my fuel line shipped out?
- Wahoo order Out!
- "AGP" screw in IAT
- hey AGP quick question on this turbo
- Any chance the Stage 4 kit can be upgraded?
- 10 psi on 50 trim ??????
- i was pissed and happy in the same day
- AGP WGA questions...
- turbo help
- New gt-40 dyno numbers....!!!
- DTEC Graphing option *still waiting*
- New GT-40 Owner
- next mod
- What air intake??
- BOV ?(attn ben)
- Need new AIT sensor for UHP
- Do you guys rebuild turbos?
- Fuel Return Line Kit Problem
- I want raise my psi with my APG WGA?!?!?
- EGT Where
- Whats the wait time for UHP/LHP?
- Just order the HKS and you uppipe, have ?
- Hey AGP
- Question about turbo I shipped
- Hello AGP
- Lose Dab with wga?
- Fuel Return Kits, Back in stock!
- Need To Check On Order
- Ben, i got a broke turbo
- Adapting an Injen intake to your 50 Trim
- WGA.....stages?
- Upper Hard Pipe Option for Stage 4 Kit
- Only 5 PSI after stage 4 install question
- rattleing noise
- 50 trim problem, canīt boost more than 15 psi
- coolant line fitting size?
- what is goin on?
- heat shield question
- AGP can u do me a favor ?
- Intake availability?
- Dtec Help!
- 50 trim questions
- dyno'd 50 trim today 382 whp 20 psi
- AFC Setting for 60-1 trim with return line
- Which is the best set for AGP... confusion?
- Stage 0 boost level w/50 trim on stock fuel
- New gasket for manifold???
- Ben
- AGP, Lucille and Solid Technology at it again!
- Ben - .EPS files
- Attn: Jon@AGP
- agp please provide me a tracking number
- dumptube
- hot side hardpipe
- Stage 4 install
- mbc adjustment
- waiting over 3 weeks for stuff!!
- return line
- Shift Selectors Back IN STOCK!!
- Base map
- Turbo Selection Question 63 Trim T04R
- agp 50trim kit. what all fuel do i need?
- AGP Cold air intake
- Does any one know where....
- Hey Agp You Got The ...........
- AGP UHP with Sensor
- Beginning to remind me of the PS2's 1st day out
- What's the hold up with the return lines?
- dyno a/f question
- Stage 4 First impression.
- Return Line and Alum Bushing....
- May be a very stupid question
- NICK! or anyone that knows
- Any issue with Dtec v 1.00 ?
- Harness Slots
- Is my boost gauge bad, or is it the surge
- DTEC-FCBC question
- Tial and Turbonetics Evolution wastegate question
- AGP UHP w/ RFL and Stock BOV
- AGP WGA and 50 Trim
- 50 Trim fuel question
- fuel return line
- agp need dtec help
- cai intake inlet hose question
- How to take off blockoff bushing?
- Some One Please Call The Revitup
- fuel question
- Dtec help!
- Orders from Jeff@RealTune
- hard pipes
- hey guys
- 60-1 setup?
- so what view on 50t/gt30 on direct FMIC?
- Ben, ?? for ya
- Question regarding walbro 255
- Question about rough idle
- stumbling
- Hey Guys, some order questions
- Hey agp Had a little problem ......
- Someone from agp please HELP........
- New Manifold first impression!
- Standard .50 trim to DBB installation help
- Dtec FCBC
- Installed agp motor mounts!
- My turbo is surging :(
- hardpipe ?
- Dyno graphs please....
- order#3208 info
- Today is the day!
- Big ol snail looking thingie...
- Shift Selector
- Ben or Kevin - Please reply soon! thanks.
- warranty???
- New toy came in
- Balance shaft chain