- Kinetic WGA install
- Next mod for my 05 ACR
- glass impregnated nylon spacers for heat shield???
- where to buy S2 wastegate?
- Another Exhaust Question
- ptp wast gate
- White smoke near heat shield after WGA install.
- turbo xs dule stage boost controler
- Profec B SP2 remote switch problems
- What Should The Next Mod Be?
- CEL problem
- Turbo XS DTEC boost/fuel controller
- A/F mopar gauge
- W/i
- Installed big FMIC n have some prob
- Installing AGP WGA: Do I need to go buy new vacuum lines?
- DAS ported TB dyno results
- $750 to spend....what should i do?
- Dynoed my stage 3 today
- HKS Blow Off valve...
- ***whats safe to boost???***
- stage 2 problems
- turboxs boost controller
- Best Hi Flow Cat?!?!?
- Drove an evo 9 today.....
- HKS SSQV Installation
- Parts and tuning
- P0133??
- top engine mount bolt part#
- is stage 1 supposed to show a code?
- Wideband & Mapclamp installed and tuned - ?
- Did I get lucky???
- Stage 1 Install For 04
- Gas mileage for aftermarket cams
- Mopar BOV
- PTB solutions???
- is the bleed needed when using the AGP WGA?......
- Apexi Turbo Timer Help.....
- agp wga on stock pcm have codes...
- BDJ 3" Racepipe
- MAXXFAB Modified Borla Exhaust
- Stock WGA was tinkered with...
- any agp stage 4 around here?
- a little tuesday night racing
- Agp Bop Bolts
- stage2???
- Question on possible boost creep?
- spring mod and open downpipe
- Next Mod Help!!!
- map clamp ????
- SRT agp/perrin intercoolers!
- HKS blow off valve install ?
- is the exhaust vital
- finally my custom pistons
- s0 05 vacuum line diagram MUST SEE
- Stg3 w/toys Question......
- I hate when things dont go right the first time
- Heat shield bolts, wtf.. :(
- BOOMBA BOV allows compressor surge?
- Got and installed prothane mm inserts. Do i need a tranny mount?
- cat CFM question
- Dual Stage Boost Controler Switch Question
- Just installed my Mopar BOV, Impressions...
- AGP WGA with PTP Spring......what to set it at with stage 1
- I'm having problems on the Dyno!Boost Drops, & Surges!!!
- tried for 300whp didnt happen
- Boostn Help
- Budget Turbo Dyno Results!!!!
- Stage 0 and safc need serious help
- fmic pictures
- What next: AGP WGA or Maxxfab DP?
- lube on inserts?
- Breather Filter
- Need advice on future turbo plans
- What to use as a 'voltage switch' for PTB eliminator ?
- which bov?
- Flutter Noise
- dule boost controler
- Bov-diff. Springs???
- Stage 2 WGA
- Stock Turbo Boost Maximum
- Using emanage/e-01 to control water injection
- Stoked
- Stoked
- Stoked
- boombo fuel rail ?
- Stage 1: instant "plug-in-and-go" gains or "learned" performance?
- HELP!!...question about reading map voltage
- AGP Billet WGA Question
- How high can I raise my boost safely??
- need some guidance
- forge wga installed... have some q?'s
- Boost Leak Question
- Need help on prothane MM Inserts
- Stage 2 or turbo back exaust???
- modern performance customer service question?
- stock cat + sniffer, a/f accuracy? dyno sheet inside
- Running mopar and hks bov same time???
- This noise is killing me - help troubleshoot
- help with RPM's hanging
- does ANYONE have a WORKING mopar bov how-to?
- Didnt know where else to post this......
- back pressure
- Type S
- the biggest leak in the world...
- Will Crane 14's Work??
- another wga question
- Stg3 owners tell me your spoolup.......
- Mopar info......?
- S2 w/toys + kinetic WGA question
- What To Do Next
- Funny Smell?
- opinios ebay dowpipes tsudo,greddy,xtune
- performance-trends boost controler?
- traction with stage 3
- Bov-louder Boomba Or Forge??
- MBC problems
- Is stage 1 worth it for my mods?
- Ed side exit exhaust?
- need some serious help!!!!!!
- is this hurting my performance?
- Looking for an exaust..need opinions. :-)
- Injector question
- Stg2 Map sensor on Stg1 Pcm
- new srt-4 owner and dont know where to start!
- A/F gauge help asap!!
- TurboSmart Boost TEE what do i need....
- Quick Question about my BOV
- mopar cai/dc sports strut tower brace alignment
- surge?
- Block off Plate vs No Block Off Plate
- DCR Mod ROCKS!!!
- Clutch feedback?
- muffler idea...
- Stinky Srt ?
- perrin bov
- AEM Short Ram Intake Help!
- best exhaust ?
- Stock Internals
- Air fuel controller?
- Stage 2 no toys question.
- why need miles for stages?
- The SRT-4's Potential...
- stage two asap please help!
- clutch goin at 12k miles
- Surge Valve
- Forge WGA HELP
- Never had a STS, here's my thoughts on a Maddog.
- can someone post a pic of the tranny mount?
- how to install
- Super Boost!?!?
- mbc install
- Dynoed today...
- who make a good shift knob?
- boostin 0 with the new agp wastegate, can somebody tell me what wrong??
- got dynoed...
- 4" intake
- Question on JMB ultimate CAI and CAI in general
- AEM CAI install instructions needed !
- 02 pipe installation
- T67 and Fuel Question....
- Stage 2 install, what a nightmare
- Jackstands!?!?
- Lower motor mount, where is it?
- catch can not catching enough oil.
- check engine light after boost controller install
- 20PSI with a Toggle switch, HOW?
- stage 1 boost levels
- Boomba BOV
- Engine Mounts
- Injen DP owners need pics of your dp please
- Dasmopar Map clamp install
- Intercooler pipes
- Blitz DTT w/Boost Gauge
- Question about exhaust
- Wga Help!!!
- Just installed boost gauge, question about top dash..
- need help quick!
- stage 2w/toys wiring instructions
- How does everyone have there wideband setup?
- Wideband question??? HELP
- Where to get an o2 housing with 2 bungs????
- AGP BOV conversion plate, leak or no leak?
- Stage 2
- Snow Performance?
- C-16 fuel cell in trunk....
- tuning
- return line ?
- ***Boost Controller ???***
- S2 WGA w/ S0 or S1 PCM
- GReddy Remote Boost Switch
- need serious help, 60trim installed, p0172???
- Help With Aem Cai Installation???
- polished radiator shroud
- Stage 3R turbo outlet size?
- MaxxFab SEE vs DTBE (modified Borla system) Owners Thoughts?
- Used stage 2 w/toys.. Will it work if toys are not installed?
- Better clamps to fix the leaking stockers. We have a kit for you.
- ***Problem with my AGP Wastgate actuator****
- Modding MOPAR BOV (eliminate blow-off when not under boost)
- MOPAR BOV vs. Forge Motorsport Blow Off Valve
- match up ? (mods vs. 350z)
- cheapest for stage2 and stage2 w/
- Eliminating the Factory Boost Leak known as the Vaccuum Ejector
- TB question
- modified borla with gt3071R?
- Boost in DAB 3 on Stage 2
- newb question
- stage 2 suffering?????
- Stock VAC lines kenetic WGA
- Mopar CAI Installed
- Running Direct Port N20?Help Me Out.
- more stage 2 problems
- Maddog STS
- When engine is COLD what's ur VAC. at???
- how to get traction
- AGP Wastegate....setup suggestions.....
- Boogers review
- Hks Owners
- SRT-4 Turbonetics Pressure Pipe with Raptor BOV
- Max ptb?
- Stock srt-4 versus stock 2005 evo from roll..
- Mopar cat delete without mid pipe?
- quick intake ?
- Money ready to be spent
- ok "yea" or "no" and why
- 50Trim or 3071R w/HRC Portfueler
- greddy bov ebay new less than50??
- weird noise???
- Shock from Engine
- quick question....
- Anyone running a TurboSmart Vee Port BOV...
- code P1188 FIX!
- shooting for 300 whp....
- Water injection question
- fmic
- Shift Tite Bushings are smoother than Booger Bushings ...
- waitin for thepowertowin to say ::::
- Leak at BOV question
- Stage 2 without Tip or Injectors ?
- Boost gauge flutter or leak??
- PTP needs a stage 3 test car, new big wheel.
- MAddog 80% STS installed in 40 minutes!!!
- Stage 1 compatibility
- Boost gauge problems. Need info.
- Injen or JMB?
- stock vacuum line/ soleniod setup
- benefits of working at a dealership
- Thermal R&D Exhaust?
- Traction????