- 50 trim turbo or 3076R with my setup..
- who makes the best intake manifold
- how much power on stock block?
- Damaged Turbo?
- coolant
- Turbo Upgrade Questions
- 50 trim setup questions
- ???Turbo Question???
- anyone running a SST turbo?
- Comparing a 57 trim to a 50 trim.
- Quik question
- I have no vacuum ports pre-TB..
- Finally Dynoed my F&F 47lbs turbo
- signs of turbo wear?????
- GT35R .70intake?
- 4" boostleak tester?
- clicking somewere???
- Eagle Rods HP rating????? someone please
- What u think?
- s3 turbo setup
- 50 WHP over the stock turbo, but still looks stock?
- 47lb wheel stage 3 dyno
- stock turbo v-band clamp
- just a few stock/stage3 turbo questions...
- Rage-Tek budget bottom end builds
- Rod and Piston
- *** Brand New STAGE 3 Turbo ***
- T67/t04z/35r step inside.
- stage 2s or rc750s?
- JE 8.0:1 vs 8.5:1
- bad turbo?
- Protecting big turbo with screen or some sort of filter? or just leav open?
- IHI turbocharger!?!?!?!?! need info
- IHI turbochargers!?!?!?!?!? need info
- question about garret a/r 60
- What is the best TB!!!??????????
- Wastegate question
- boost control options with agp wga
- msd ignition box
- which rod bearing
- What pistons for 500whp
- 05 SRT-4 Ticking after wg install
- some GT3076R questions
- Do turbos lose performance over time ??
- wastegate sizing
- stuburn bedplate
- Bent Turbine fins on 3076R,big problem? PICS!!
- What could have caused this???
- Anybody running a S3 PCM with a 3076r?
- Which setup for a street monster?
- New set up.
- NGK 4306 Spark Plugs Pre Gap
- Spark Plugs Gap
- Oil in turbo inlet=blown turbo?
- stock turbo turbine housing
- engine build 101
- Has any had this happen to them
- i ordered a coolant overflow reservoir and i recieved this?
- anyone run a hybred holset hx35/hx40
- How much is it good for? (HP)
- Turbo inlet Reducer
- Custom Big Turbo
- Please Help
- rebuild kit or new turbo+set up?
- 22psi rad cap?
- clearance with je 8.5:1 pistons,+1mm valves,bcs3 cams?
- no oil pressure!!! help!!
- smoke after letting off the throttle
- Hydro-lock
- crank strap kit info needed
- what is this? can someone help me out...lol
- hybrid time!
- NGK 4306 Spark Plugs Gap
- Identify this BoV?
- GT2871R vs APG S3D
- T3/T4 turbo upgrade?
- Leaking oil...
- What the heck is this? 56k = :(
- argh missing bolts off manifold...
- Timing Belt
- Car running Hot after damaged fuse!
- turbo/wg line question
- Help, JE Pistons 8:5 Compression
- How much will the stock turbo boost? im at 20
- Having problems with turbonetics wg and Ebc
- Best Prefered Stage 3 Plug Gap!
- Any ideas?
- Possible to replace the bedplate?
- stage 3 WGA help
- AGP Stage 4
- S3 help...
- stock wastegate question
- Best short block???
- 44lb wheel boost
- Transformer crazy
- wastegate question?
- spark plug gap???
- Turbo heat shield??
- Map Cleaning How To?
- Bugging Problem
- porting questions!
- Turbo manifold ?
- anyone swapped the caliber turbo into Nsrt4
- 60-1 Turbo owners? Post ur dyno and setups here .
- Stock Block?
- 60 trim thread
- help please
- Using a velocity stack / ram air for turbo cars ...
- Walmart fuel injector service?
- Surge Valve Question?
- Garrett center section/Exhaust Housing
- GT3076HTA / GT35HTA Owners?
- BWoody Oil Catch Can Fittings
- Low Boost need help
- ? about balance shaft removal...
- loss of boost under hard accl help please
- wtf is up with my turbo!
- e1 or sst
- tkms gasket
- need help Asap
- Stage 3 external wastegate mod
- needed answers!
- what turbo should i get????
- Testing Exhaust Leaks
- Looking at Kinetic Motorsports 50 Trim..input?
- stage 3 exhaust manifold ??
- Which CAI does everyone recommend?
- Question - may be stupid = are our engines 2.4 - Interference engines?
- boost leak?
- boost on and off
- oil leak?? help please
- Possible coolant problem
- GT4094r compressor/turbine map
- Who all is running a Stage 3 turbo with a Stock PCM?
- boost issue
- Stg 3 Guru's please help!
- spark plug help please!!!!
- Couple of engine questions, any help?
- Turbo oil restrictor needed? Pics..
- Oil pressure gauge question
- Tps
- bad bov?
- What Vendor sells a stock ported leak free TB?
- need some help on my new 57 TRIM!!
- motor mount help!!!!!!!!!!!!
- anyone know any ported intake/Tb race combos?
- badaboom badabang finally coming together
- Radiator fan no-go!
- Stock Turbo and Wastegate?
- radiator questions need to know asap plz
- broken boost gauge?
- bad head gasket?
- Milky Coolant
- Plug Gap
- still can't figure out my problem
- fm enforcer turbo upgrade
- which wastegate
- HELP!!!Really Bad Bogging,alot of raw fuel,floor the car and takes a while...
- Push button start
- Crane 12's Interfearence??
- 2003-04 mopar stage 3 kit for 2005
- thinking about turbo
- What Cams Should I Get???
- catch can???
- Main Stud Kit
- Stage 3 turbo
- built engine question
- my motor is disassebled few questions..
- Mopar Stage 3 Turbos Discontinued?
- Question about Mopar Stage3
- Turbo Surging under high boost?
- Coolant plugs
- help i.d. this turbo
- bad lag on stock turbo
- t67!?!?!?
- .030-.040 piston who makes them
- Anyone know the torque setting for Eagle rods?
- Head Gasket\Cracked Block?
- timing belt cover....needed or not?
- Rods/Pistons Help
- Huge decision and i need help... PLease
- name this part?....
- Looking for pics of JMF intake installed
- wastegates?
- 62mm TB install...now car idles high..does anyone know how to adjust it?
- Spark Plugs?
- 5 blade compressor wheel?
- info/advice
- figure out my problem
- 10 bucks to whoever solves my problem
- Car sounds strange after big turbo
- JMB Performance Small Battery Kit question?
- GT3076r question
- MSD dis 2
- 50 trim question.
- removing the red vaccum line
- want to build engine
- For those of you who know about turbos.
- Balance shafts removed & oil capacity grows???
- What spark plugs and wires???
- supportable HP????
- MSD Coil Pack Question
- 22psi on 93?
- 60 trim 1.15 a/r
- T3/T4 57trim .48 A/R housing
- oem exhaust mani bolts
- exhaust manifold bolts
- Need help, I have no idea!
- Just got the GT3076R...How much horsepower can I expect?
- please help with tensioner
- Removing the Starter
- turbo ?
- new young driver looking for help
- turbo spitting oil?
- Reusing DCR 5 Layer HG?
- Stock turbo o2housing???
- Q where to put thermostatic probe in block
- How does the ATI Super Damper for SRT4 work??
- rough idle
- 50 trim question
- 300 hp??
- Exhaust Manifold bolts
- Sick FFP S3 47lb dyno!! **pic**
- after 2200 rpm my car has no power
- Big wheel stocker's are us!
- high oil pressure, what is causing it?
- quick AGP wastegate question
- Hi Im New To This
- EGR Valve
- 60 trim with .48ar laggy
- Oil Drain line, bradded, have u done it?
- FM E1 Turbo with Tial 50mm?
- Oil leak problem?
- s362, oil question
- What Turbo?
- Weird problem after changing WGA
- Newbie Turbo Question
- Oil restrictor with journal bearing turbo?
- Modded stage 3 turbos worth it
- Another Tone Wheel Failure ? ? ?
- just installed/ran my motor and a few ?'s
- S3 manifold w/ external WGA *pics*
- champion iridium spark plug gap?
- question for the 20g guys
- waste gate question stuck closed?
- crank sprocket puller tool?
- help with crank key!!
- spark plug gap help
- How do you feel about......
- 2.6 Stroker Tone Wheel Failure . . . The Aftermath