- leaking o2 housing
- ~ Need New Exhaust o2 bolts and hardware ~ Help !!!
- 4.5 knock... what to do
- Budget Bottom End Build?
- 37 psi boost dyno video...
- Anybody using this external wastegate?
- Stage 4 or....
- Question on compression
- Before and after on DCR Pro Series Head...
- Built Engine Properly Assembled?
- Options for a big filter kit?
- GT3582R... Some questions..
- spark plugs
- wastegate re-route question
- question on knock!!
- Stage 3 delta (40lb) VS Mother Mopar Stage 3
- Ported Turbo Install
- Solenoid 2 Vaccum lines
- mopar bov spring upgrade
- Stock turbo removal question.
- stage 2 injectors & Turbonetics T61
- Coil pack/plug wire combo
- 2.4 block
- overheating???
- who in the hell needs this?
- need injectors perhaps 440cc or above
- Oring The Block Help
- closer to solving my misfire
- do these stock turbo exhaust fins look right?
- turbo is in PIC*
- 16g Housing Question
- Spark Plug Blow Out
- Turbo For '05 SXT?
- Tried boost leak test. Am i doing it wrong?
- BoV problem with new Big Turbo. 60Trim
- throttle cable routing
- Does disconnecting your TIP cause slightly rougher idle?
- Spark plug gap
- WG dumptube question??????
- need your help (smoking)
- want to build stock turbo
- Flame Issue
- 450hp on stock bottom-end?
- stage 3 DAB with external wastegate
- Wich turbo do i want???
- Kinetic 50 Trim
- AGP Stage 3 Delta (44lbs/min)
- turbo kit question
- 20lbs of boost
- Am i going to be happy going big turbo if...
- where did the boost go???
- Gt2871r
- stage 3 oil leak ?
- Torque specs??
- please help!
- Building Engine, Would Love Advice! Please!
- Coil Pack and Wires??
- Need some advice
- Cam Magnet?
- Msd Dis-2 help
- t-bolt clamps
- tuning Turbonetics T61......
- Turbo questions
- Plug Gap With This Setup?
- How To Replace Oil Pan
- help please stage 3 oil leak
- Is this the proper way to have a boost contoller setup on a external WG?
- Stock Turbo coolant line arrangement question
- t67 and gt35r
- New Mobil1 oil...
- where can i pick up banjo bolts for stage 3/stock turbo?
- white smoke at idle?
- Coolant Overflow Options.
- please help stage 3 install smoking
- what turbo??
- Smoke from turbo housing?
- Finally decided!!!!
- Rebuilt, Funny Noise, Help?
- Has anyone had this problem???
- UPP pipe
- what the @#$!
- manifold brace
- heat shields
- Bov?
- Dyno Sheet!!! Intake Manifold??? Power Loss???
- precision rebuild
- hahn portfueler
- Higher Compression on stock fuel
- Oil leak?
- Crank walk
- td04lr oem, what will bolt up to stock t-mani
- Oil leak, backside of engine near alternator
- CAI do suck in water!!!
- TurboSmart BOV
- Overflow bottle
- blown turbo?
- Dropped Foil in Oil Filler - what to do?
- Turbonetics BB T61 zex 50-75 shot install...
- Colder Plugs
- new engine build
- no boost
- Stock coolant line help!!!!!
- Head Stud Info
- Stage 3???
- Need Help! P0016-CRANKSHAFT/CAMSHAFT TIMING MISALIGNMENT
- auto meter tach adapter
- Hann 20G 3" o2, should have these ready....
- Helpful Reading for Newbs!!!
- ported stage 3 manifold
- new agp turbo kit
- *car stalled & now 3 codes!!??
- ported stock turbo housing
- turbo to manifold spacers
- HELP!!!!!!!Oil Pressure Sensor Low
- New Engine
- anything else i need?
- ext. wastegate gasket
- what manifold
- some DIY help????
- question about turbo and kms
- Cant find NGk 4306 anymore in SoFla.
- new crank?? please help
- 600whp quest!
- want to make a .50trim a beast.
- Block and Head question
- Tune-up time! But what wires do I want??
- Coolant Line ? GT Turbo
- stock vacuum reading at off throttle?
- Cracked Oil Pan.. Blown motor help!!
- Evo 8 Turbo app.
- MBC failed let turbo overboost NEED HELP
- Smoke
- Gains Adding Intake?!?!
- STOCK boost problem!!!
- MSD ignition question
- 03 SRT4 valve cover help!
- Is there supposed to be a gasket between the exhaust manifold & O2 housing Stage 3
- broken bolt in head HELPPP
- High Pitch noise in boost
- Whats the torque spec for the stock surge valve bolts?
- Borg Warner S362???
- intercooler ?
- Big 16g compressor wheel
- turbo problems?
- anyone has this. rippmods 16g
- over heating prblem
- Need help
- Explained-Why turbochargers fail.
- Boost Leak at the Throttle Position Sensor...
- Strange noise in boost
- Another odd evo 8 question
- GT3076R with .83 ar manifold
- spark plug shock!!
- Any Helpful Hints Out There
- Idle Air Control Solenoid Bolt.
- spark plug
- How much boost on a .50trim
- SSTV2.5 dyno 355whp 440+trq.
- Spool difference?
- Ebay Turbo? Want To Order?
- Boost Problem!!!
- what size clamps
- stock turbo vac lines
- o2 housing bolts keep backing out
- building motor and i have questions
- cai and 50 trim
- GTK turbos on SRT4S?? HELP ASAP
- Spark Plug suggestions
- balance shaft
- battery relocation kit
- How much boost can i get?
- Accel Coil
- Oil in pipe, help!
- new set up
- 10mm bolts for Blow off valve
- How do I fix this ? PIX
- weird noises after BS chain removal
- Lets talk about the stock oil system
- time to replace turbo
- Opinion Please
- Motor froze?
- Stage 3 gaskets
- MSD Coil and Wires....
- need help with vacuum harness?
- opinions on 60trim
- rod knockin
- New 50 trim, NO boost
- Help this is weird<<...
- just got 50 trim
- High Idle HELP!!!
- Boost leak problem... PLEASE HELP
- MSD 2 bar Map Sensor??
- 50 trim air filter
- boost leak on stock surge valve
- Need engine building reference sites...
- Radiator questions?
- Turbo/Boost gauge problem
- EBC boost issue, need smart people.
- need feedback on accel coil pack
- Where is this oil leak coming from?
- need help with hahn16g
- What Should I Gap My Plugs At!!!
- Oil Change
- Coolant in my oil... help!
- I Need A Short Block. Vendors?
- First trip to the dyno...
- S3 o2 bolt size?????
- Need your opinion
- Help... Coolant leak
- Spark Plug Wires
- Pic's of my ported AGP 3076
- Help!! Exhaust giving off smoke!!!
- stock turbo
- Did I break my Timing belt tensioner?
- Piston Damage
- wastegate installation
- Power steering belt tensioner WTF?
- Is this the correct part number?
- stock turbo
- .020 over, is it worth it?
- Evo 9 turbo question?
- EVO 16g turbo question
- Losing lots of oil??
- difference in ring gappage?
- Gt35
- Will any other turbos fit the Hahn manifold?
- crane 22's
- Best cams for me? I'm thinkg BC stg 3's.
- FMIC? makes car run hot
- What makes more power? S16G or stage3
- Help With Engine Problem...
- turbo support bracket fused
- I hate these threads, BUT...
- spark plugs
- 60 trim owners? post your dyno & setups here.
- PCV replacement????
- bead blasting 50trim manifold
- Installing stock turbo need HELP!!
- Turbo rebuild
- has anyone heard of these sparkplugs
- PCV valve. Sealant on threads.
- VAC loss?
- turbo oil feed line
- oil in my intake
- Convetional Oil to Synthetic Swap Myth?
- need to know if i have a bad turbo
- i need help to all you srt4 Junkies!!
- agp vs ams
- e1 on s0 car question
- ck this out