- Check Engine Light
- Overheating
- Stock WGA seems to be gone..Help..
- Building HP engine*INPUT NEEDED*
- Catch can not catching anything
- oil leak around dipstick?
- federal muguel or stock bearings ??
- Hotside Pipe diameter
- should i buy a new crank
- Turbo Charger leaking...anyone else have this problem?
- msd dis-2
- SRT-4 engine transplant *I need your help!!!
- MSD DIS Users?????
- What other engines will the stock srt4 turbo manifold bolt to
- Ok wait, 3" air instake for a 2.364" TB???
- to bore or not to bore ?
- SRT turbo on a 97neon
- Weisco pistons
- SRT Turbo causes extreme EGT temps?
- Spark Plug Gap
- oil cooler and filter relocation
- Factory Charge pipe replacement
- Quick turbo question
- securing a BOP
- msd tach adpater
- those with COX built bottom end
- Better than Darrel Cox motor ??
- Check you Intake Mani
- Special Engine Coolant Only.....
- oil pumps, i asked, you replied. group buy.
- Headgasket Q's
- oil in water need help please
- Those with Wiseico Pistons please read
- Does balance shaft chain make noise at WOT
- upgradded oil pump for those that have...
- coolant
- Timing gauge or knock light?
- shaft play
- rod barings
- Need oil line kit
- need help moter ir knocking
- need piston rings
- need piston rings
- ecotec block vs srt-4 block
- Turbo problem
- Anyone try this ODB-II??
- n00b question -- was this a flooded engine?
- PT cruiser turbo upgrade fit SRT-4?
- Turbo Upgrade Advise.
- 2003 Oil Cooler
- Engine Sputtering = Fuel Pump??
- Need Help!!! Turbo Problems!!!
- weird clicking noise from engine?
- I need help with something!!!
- INFO: SRT Dyno Sheet Discussion thread
- INFO: Official SRT Dyno Sheet Thread
- Questions on pulling motor..
- Cooling Line for Turbo I guess
- personal prefrence on oil
- Stage 2 Wastegate Actuator Number?
- when are headstuds needed
- '04 Valve Cover on '03
- Turbo quality
- Oil Cooler took a dump...
- Swapping a STR-4 Motor into a 2G ACR
- getting a lot of boost surge, what to do?
- Downpipe problem
- Compression test???
- running temp
- Turbo Question...
- Oil on Hardpipe........Bad!....Right??
- Re-Gapping my plugs....
- turbo oil leak
- Mopar 100psi oil pressure gauge install
- spark gap
- Turbo Question
- Stock turbo - who makes it?
- what plug and what hp guide
- 7000 RPM redline ok with stoc internals?
- How Much Is Too Much???
- Msd Ignition Coil
- A little confermation
- Need Help. oil line copper washers?
- HELP! Turbo Problem
- waste gate
- Screamin Demon ignition coil....
- P/S pulley
- What spark plug wires should I get?
- spark plug help fast plz!!
- Is my stage 3r turbo &*^%#$?
- help my friend!!!
- srt4 is mercedes? Engine content and build parts from MB?
- radiator hoses question, SAMCO or Perrin?
- Engine knock
- Questions on 180 thermostat...
- 180 or 160 thermostat?
- Cant find a diagram for MSD DIS 2/Tach adapter install
- Engine Sputter
- Aftermarket engines?
- What's the deal with my turbo?
- Check valve with Crankcase Breather
- Check valve with Crankcase Breather
- coolant
- If I had ring damage/blowby would I see smoke/consume alot of fluid?
- Help Needed---quick!
- motor mount ?
- high idel and PTB issue
- Round Two B!tches!!!!!
- Motor Mounts Blown
- Compressor map calculations...
- Looking for billet oil gear/pump?
- How's my spark plugs look?
- anyone have removal, install engine directions?
- Guys with stock motor mounts...
- I screwed something up. Help please...
- I need help with a sensor
- overheating help
- AutoTap w/ Chrysler Pack?
- Oil Drain Plug
- looking for a datalogger
- Help with CEL
- dis 2 users please read
- car spudered at wot
- Low Boost...
- PCV question?
- Link to windage trey and scraper
- Think turbo blew?
- Starter Problems?
- good upgrades for cheap
- Stage 2 WGA and MBC
- Late model Tach adapter 8917
- blew the motor
- new performance head gasket
- Oil Filter?????on Cobaltss
- vacuum problem-i think????
- Help!
- balence shaft remove it or leave it
- Spark plug gap
- white smoke w/ letting off throttle
- code P 0303
- ticking?
- Rod knock?
- Rod knock?
- NGK Spark Plugs
- Required Torque for Eagle Rods?
- Swappin heads...
- Say I wanted to change my pistons ...
- Help For Pounds Of Torque
- Possible bad rockers on 05 SRT-4??
- is my turbo sead
- Wierd Turbo Noise
- coil wire question... need answer quick
- New question about "ejector tee" and vacuum/boost...
- Turbo cool down
- Pin Out Signal Chart of Diagnostic Port
- Engine light ?????????????????
- SRT-4 engine/tranny swap into 04 SXT?
- balance shaft removal dynochart?
- I know SEARCH !
- honing question
- check it out.. Ultra Oil Filter
- torque settings for the SRT engine?
- 2.0 sohc more idea then 2.4 swap.
- 180 stat/water wetter and still running hot
- heat shield - Upper Turbo
- taping in motor
- Cycle Kits
- ting tling tling ting!! hearing noise!
- Only making 6-7lbs boost
- Intercooler hose split!!!!
- Wastegate Configuration Info Needed
- EGT's going crazy!?!?!?
- Anyone's Srt Fluttering?
- A clicking in my turbo...
- Who's lost their engine....
- Throttle sticking and other issue....
- Forge BOV NO more sound??
- bottom end
- Fuse block?
- how do you if you have bad distribuor/wires etc/
- Big boosting problem!!!!
- question
- Need advice on where to put....
- Car fluttering....why?
- Compression Test on SRT-4
- Really hot or what?
- Forged pistons and rods
- 10w30 or 5w30?
- runnin open turbo, no piping or filter
- Problems after installing Boomba Mounts
- 350-450 HP on stock Long block........ How long will it last ?
- rods...
- wiring harness connectors
- Idiot lights...
- engine rattle
- Install on Turbosmart MBC
- Best way to run O2 sensor wires from cabin to dp
- Why?!?!?!?!?
- garrett GT3071R turbo ?
- Special Coolant tank help
- New Engine
- If you are doing a engine build up
- oil on spark plug thread only
- New Motor Mount Advantages vs. Disadvantages
- Looking for Reinforced Head Gasket
- Removing the engine
- weird sputter
- Is a problem 30 PSI on stock turbo
- still lost after ignition search
- Need tips
- i got a weird problem
- how do my plugs Look?
- Engine support Bracket
- would a boost leak cause...............
- rebulit motor questions
- What does your boost gauge read with the car off? At idle?
- Do SRT's have interference engines?
- Safe EGT's
- what is blue printing?
- Cryo engine parts?!
- Pistons?
- Thermostat question
- I can't get past 9 PSI any suggestions?
- How do you install a Head Gasket?
- Side by side pic of Eagle/ factory rods
- what gap will make my car with just stage one pull harder?
- rpm strange
- DCXPatent: Variable exhaust-gas turbocharger with an auxiliary drive for an internal
- Fuel cut PROBLEMS...i think
- Gap for spark plugs, help please!
- car won't idle
- How much VAC with engine off???
- I need Stage 2 input please!!
- 3.5 litre shortblock for the SRT-4
- Extrude Honed Manifold & Head
- Cut the chain and removed the plastic guides.
- slight surge caused something?
- swaintech GC on stock pistons!!!
- newbie question
- Bosch Platinum 2's
- Throttle Body Help?
- Balance shaft removal results
- JMB upper pressure pipe w/greddy bov and AEM sri???
- Wiseco Pistons
- Different gas??
- Turbo temps too high.
- weird ilde issues
- oil pressure tap for an autometer
- Engine Firing Order?
- checking for leaks