- BW S360 owners? post setups & dynos here
- Calling All Delta Turbo Owners Please Review Your Kit
- Turbo Surging?
- Has anyone had any smoking issues...
- external w.g. problem
- New short block questions . . .
- 2.0L in SRT 4??
- complete engine replacement
- e1 question
- rod question
- afr stage 2 wga
- Oil return line to block with tubular manifold
- Max Boost on forged internals?
- Agp turbo kit install nightmare!!!! Help me
- Agp Turbo
- SRT-4 stock turbo
- e1 turbo and holding boost
- So what is it that makes the bottom end go boom?
- SRT4 motor swap into a 1st or 2nd gen??
- qestion
- stock turbofold flapper broken?
- question.......
- what turbo inlet and drain sizes should I use
- Cylinder bore / piston fit question.....
- Intake Manifold Flow Modeling & Simulation
- first turbo upgrade help!!!
- FYI: Sputtering problem at mid rpm range (2-3k)
- oil/coolant feed return lines (please help!!!)
- Stage 2 plugs and wires?
- Slow Spool 54Trim?
- e2 on stock manifold max boost
- is this s3 turbo any good??
- HELP P2302 code
- turbo has no pressure fitting, how will I control boost?
- 50 trim questions..
- moderator
- NGK-LZTR6AIX-13 Where to buy??
- Another stocker question...
- AMS performance parts
- New turbo arrived today
- spark plug gapping?
- How can I remove engine from top
- stock wastegate
- Oil Pressure Gauge
- where to buy twin turbo manifold
- balancer chain removal??
- blown turbo return line
- stock turbo replacement
- msd coilpack
- Surge Valve Bolt size help???
- please help
- Turbo Upgrade parts?
- which turbo would you choose
- Guys not running Windage trays / BS assembly
- What Turbo Is This???
- How do I set vacum lines on "big" turbo setup?
- New numbers!
- ARP head studs and 5-layer head gasket
- parts list for a built srt-4 engine
- Blown Turbo at 25k miles?
- Quick Stage 3 install questions
- dcr stroker
- 60-1 @ 26psi = 424whp
- 700 hp short block parts
- Stock head / studs max psi?
- Where to order TiAl WG in Red?
- Goal 450whp..... but Should I...
- Spark plugs for Stage 3
- part number for Banjo bolt from stk coolant to turbo
- Newb questions for all to answer
- Changing out Spark plug wire
- Need quick help
- 50T or D44 for Street Setup? And other questions...
- Somebody tell me what turbo I have, Please!!!
- evo turbo
- smoke question
- Time for rebuild???
- Smoke from Dipstick and Oil Cap?
- 2.6 liter stroke help
- Stage 3 kit?
- Pump+meth+D44= :)
- blown turbo?
- Rage treated oil pump gears are back!!!!!
- Cheapest place to buy Crank
- Spark Plug Gap
- Rebuilding MOTOR!! quick question
- 50 trim time
- Evo 8 turbo stage 3 AGAIN...
- supreme n00b questions
- Im thinking rings still....???
- need some suggestions
- Rebuilt motor questions
- Ptp Performance
- ext gtd stck mani w/ bolt ons
- Oil return line??
- Cylinder Boring limits?
- 50 trim or d55? or what
- turbo to make 550hp
- Help! Return Coolant Line For Turbo!
- New Motor Feedback
- What else is needed? D44 install help -pics inside-
- Need to replace trigger ring. Have questions...
- Big turbo install problems
- alum. radiators?
- Mopar stage 3 power?!
- motors out what mods u suggest?
- Mhanmer87 build thread
- About ready for build would like feedback
- rod bolt torque specs???
- Deck tolerances
- stock exhaust manifold replacement help
- Tdo4lr turbo???
- How do you think this would work?
- Any Bullseye power S259 owners?
- need a 20g
- Part #'s for stock turbo oil/coolant fittings
- Turbo Parts???
- melted pistons?
- Stage 2 Boost Spike - Dyno Results & Questions
- All Atx srts
- need help with s3 w/ toys
- Please help..
- safe to up the rev limiter
- 50 trim compressor covers
- Delta 55, pump gas, dyno numbers inside...
- Purge solenoid
- SS Braided lines for turbo oil/coolant lines?
- Couple of Questions, need help deciding
- Need my S3 rebuilt, get some work done on it?
- turbo rebuild
- 35r question
- strange boost leak
- Oil pump sprocket / Lower Timing Belt gear
- 360 thurst bearing.
- Anyone else sell crank straps besides DCR?
- banjo bolts for stock turbo
- HTA or NOT
- Forward Motion E1 turbo
- need turbo
- All of you that have DCR's Twin Turbo setup
- No boost
- stock turbo question
- A/C Bracket Bolt??
- internal and stuff
- Stage 3 turbofold install, what is needed?
- 35r or delta 48?
- Input from a 50 trim going to a S3
- any one installed the evo VIII turbo?
- What turbo is this?
- need help with vacuum lines on semi stock setup
- Smallest Turbo on DNP Manifold
- 50 trim?
- o2 downstream?
- would it be worth my while....
- big turbo build starting this week...
- Oil pressure gauge install ?
- Biggest turbo for DNP manifold
- max overbore?
- 250 miles and quart low after change?
- stage 3 47lb wheel Kliped or stock
- Stock Coolant Feed Line help..
- what turbo kit should i get?
- What should I do.......
- help me finish my setup!!
- what other valve covers would fit
- GT3076R Owners? Post Your Dyno's and Setups Here!
- valve cover leaking..how to fix???
- engine
- oil throught turbo?
- Thermostat Housing Bolts?
- dohc indy intake mani some problems
- i wana hit 400hp
- FP-green s3 vs 47lb compressor swaped s3
- Should a $1000 Turbo come with gaskets?
- Why 20 over?
- Dcr E1
- Cheapest place to buy a GOOD turbo blanket?
- e2 problem
- best turbo for my set up.. final
- Stage 3 Delta 44 dyno/setup
- Doublechecking my Big Turbo/EBC/WG Vac Lines
- Stock exhaust manifold question
- Need Help on a lil hose!
- where to order new VC bolts?
- normal psi
- pm me for details on how to be a vendor
- what can it be if..........
- e2 records
- Question about stage 3
- Cams
- stock turbo
- Crane 14 Cams
- Official: Ported Parts Thread
- motor is toast. Turbo PT motor okay to use?
- Does anyone still make a 60mm throttle body?
- Break in for new factory block?
- 50 trim rebuild
- turbo housing
- GT42_Boost_Build
- Who has MAXED out an E1/Shocker/SST?
- i have mopar stage 3 and....
- Main bearings part #
- new pistons/rings/HG now what?
- Best Intake and TB for Big Turbo
- harmonic balancer pulley
- High flow pickup tube w-screen
- File Fit Rings
- blown rings on a newly rebuilt (relatively) motor.
- stock turbo oil line question
- fan relay check?
- TD06 turbo question..
- Pulstar Spark Plugs on dyno!! by What Neon?
- 60-1 turbo rebuild
- how much power?
- AGP TBB Step 4 Help
- Exhaust Manifold studs
- rad and cooling fans
- Quick AGP 3147 repair kit specs question
- Blown stock turbo? Repairable?
- stage 3 FP green questions
- Timing Belt Broke!
- piston question
- What did this guy do to this engine??
- Engine Build Advice
- s3r vs 16g6 compressor wheel
- any intake pics
- Name that turbo!!!
- turbo oil drain
- Hahn super 16g
- Found bolt laying in oil pan
- Current Engine Build
- sparkplugs and wires
- Compiled List of SRT4 UOA's
- Oil Pump Removal Problem
- turbo ?
- Shavings in oil
- hawaii help
- Timing Belt Purchase?
- SG256 or SG258
- Anyone kno alot bout turbos?help..
- Turbo Question
- Anyone using a synchronic wastegate?
- How to tell new short block?
- TDC and timing belt question
- build insight
- Oil usage / consumption
- Operating Temperature
- valve cover
- Need help asap
- Turbo Questions --Cali people help.