- Broken exhaust manifold bolt!
- boost leak???
- Plug ?
- Lower Thermostat
- 0p300
- location oil pressure sending unit?
- p1190
- Best Intake and Throttle Body Porting
- 2005 srt4 engine
- 50 Trim + Built Bottom+ direct port=????
- GT35R Owners.... T04E or T04S
- help & suggestions on what may be wrong?
- Fitting on the block for Oil Feed and Water Feed
- T3/T67 turbo owners? post setups & dynos here
- part # for 180 t-stat?
- Need a part number
- Zapp Pulley belt size?
- Log style intake manifold
- I need some part numbers!
- engine loseing oil
- Location of alternator
- srt-4 engine
- engin trouble!!!
- stock turbo maximum psi
- srt4 engine and turbo into a stratus
- Compression Test Results on New motor
- Exhaust manafold ?
- engin problems
- Crankcase Venalator effecting boost levels??
- ooops.. possible trouble
- NGKs #2314 or Champion Iridium #9403 for 2005?
- turbo installation ?????
- What size is the factory oil return line?
- First Oil Chnage Ques.
- What turbo?
- good head gasket
- Oil pressure in a Srt-4
- Quick ?.. I need head bolt torque specs!!
- Spark plugs...nothing is working!!!
- brisk turbo spark plugs
- Silicone Hoses with Catch Can?
- NGK iridium spark plugs
- Electrical/ignition questions
- Break-in Question?
- Cams!!
- engine build question
- Regaping Factory Plugs
- Post your catchcan pics....
- MOPAR Stage 3 Turbo Modifications
- OK what do you guys think? Turbo dumping oil?
- Knife edge crank what do you think
- PCV bad?
- What about oil pressure at higher RPM?
- turbo size compare?
- Oil leaking from the turbo....HELP
- Head gasket replacement
- What's a boost solenoid return do?
- throttle cable broke, HELP!?!
- HELP PLEASE PCM problem
- anyone interested in ARIAS pistons
- Question about bottom end???
- Cam tower recall?
- where to get intake mani help...
- Bad bearing
- "Catch Can 101" Things you should know about installation "Please Read"
- fins bent?? on Turbo compressor wheel!
- squeaking noise
- Old Gauge Flutter Question.
- best oil
- Low Oil Pressure! Here is some Info to look at.
- Which spark plugs to choose?
- Anybody have a pic of OEM map sensor?
- Another 4306 0.35 gap convert here....
- how to check if you block is cracked?
- what is normal oil pressure??
- Need to replace Piston Rings
- Big Problems, Blow head gasket?
- Aftermarket Bottomend?
- 500+ whl pwr question
- Questions about Main and Rod Bearings:
- TOrque Plate.
- Coil Positive
- ok i think this is the problem
- Valve Cover Question
- 420A Service Manual Help
- 65mm throttle body, will it fit?
- Engine Tap
- j/w bout spark plugs.. quick question please help!
- GT3076R... .63 or .82 ? Big Turbo Guys
- Hmm this might be the perfect turbo
- Tubro make a winding sound
- torque specs
- Looking for stock engine specs
- 50 Trim Turbo owners? Post ur dyno and setups here .
- New coil and wires...should I change plug gap?
- Solid Lifter
- will no catch can cause a random puff of white smoke at start up
- srt4 turbo.. a/r???? brand?
- Signs of cyrotreating?
- ARP Exhaust Manifold Bolts worth it?
- GT35R Turbo owners? Post ur dyno and setups here .
- colder plugs?
- DIS-2 Help
- Dart Blocks..
- what is a map sensor
- Oil Drain Plug- Have you stripped it?, Finally an answer!
- anybody running the 50trim .82AR
- oil leak...help
- MOC multi clean sludge remover?
- help with code....
- Stock SRT rod length and Revs
- S3R turbo O-Ring Question
- How do you gap your plugs?
- Spark Plugs
- intake manifold porting
- Rotella T
- Chrome Moly oil gear set at $$$.
- Well, she finally blew up...
- so cal...need block built...
- Normal Oil Pressure?
- Syntec Blend Motor Oil Factoid
- How do you know if you blew a head gasket?
- I've got 2 codes, HELP!!
- GT3071R Turbo owners? Post ur dyno and setups here .
- New Boomba Intake Manifold Gasket?
- ARP head Stud Kit??
- intakes and combustion
- spark plug gap
- spark plugs
- Torque Specs????
- plug gapping
- ever heard of doing this? Internal WG sound like external WG
- Which do you prefer?
- Official Balance Shaft Assembly Removal Poll
- Turbo? Need Help.
- the stock turbo
- Group Buy Boost Leak Testers (Fully Built)
- Torque for intake manifold bolts
- How much psi is 50trim good for??
- need help with VACCUM LINES!!!!!!!
- Need help, oil drain plug question
- Irregular Engine Noise (vid) - help
- Blueprint and balanced
- why does the car shake...
- Tach Adapter.... Wrong Part?
- Ngk
- want to srt-4 power 1st gen neon...
- Intake manifold flange, does anyone make one?
- I'm screwed!! Spark plug broke off!!
- Looks like I'll be driving the Turbo Caravan for a bit
- end of spark plugs white??
- click
- Check Engine Light, P0325
- Oil, coolant...?
- Engine Rebuild Balancing
- Engine slow to come off throttle
- What's the Benefit of Bar & Plate vs. Tube and Fin IC's ?
- POLL: stock internals, Big turbo, 25 psi.....
- SRT4 Kit on SOHC?
- Motor Build Up
- srt-4 swap?!?!!?!?!
- White smoke from engine.
- How do I find out if I have a bad coil?
- Spark blowout, can you HEAR it? or just feel it?
- 2.4L Engines with VVT
- whats this noise? (vid)
- Seriously need help
- 50 trim dual ball bearing
- Got some questions about blown motors
- Turbo Timing
- Turbo overheat
- Motor Mounts
- GT3082R or T60-1 comments ?
- Motor Swap
- Got water in my engine..
- Stock turbo question
- Metalic Ticking Noise?
- Does Changing Gap Make you Run Richer?
- Replacing Water Pump
- Turbo Problems
- Here's another Debate... Oil Pump Gears... Why do they fail and not fail?
- Spark plug blowout?
- Rebuild kit.
- brown catch can oil
- SRT4 In a SXT
- Boost / HP on stock bottom end....
- Just got the motor started...
- cam sensor
- BS chain loose at what mileage?
- JE Piston Part number?
- Short Block Help
- AF Ratio - Help Plz
- Pulling engine: Connect chains where?
- engine rattle/clacking when rpms above 4k
- How to read a spark plug
- actuator
- Engine Building Info??
- Alright Folks time for a Debate... Balance shaft removal
- How much HP does each pound of boost give?
- srt-4 engines
- Finally Started to rebuild....again.
- Built up crate motor available?
- srt engine..no turbo?
- need help with wastegate and tuning
- Exhaust Temp. Question?
- Since my thread dissapeared.....
- evac systems
- Garrett GT turbos
- ARP officially releases a 2.4 head stud kit
- What is a T300 turbine wheel ?
- Oil causing a ticking sound?
- Flushing radiator and block..HELP!!
- What Spark Plugs and what gap?
- SRT4 Submarine
- A ridiculous, yet possible proposition
- people 570 hemi plugs?
- Engine revs on his own
- car is burning oil
- Pulleys, Belts, Etc. - Need help
- Camshft Replacement Question?
- spark gap again!
- Help on msd dis 2
- main studs
- Cant run more then 25psi?
- BIG 16g?
- stock short block
- Have you tested your antifreeze recently?
- Please Please Help I Need Sizes On T
- Block and Crankshaft
- Engine rebuild thread
- No more Colder Heat Range Plugs for Me!
- Static vs dynamic compression and turbochanging ?????
- black smoke
- #1 cyl misfire Need Help!!
- poll: running 25 psi on stock turbo is fine
- Gauge hook up
- Correct part # for Crane Firewires?
- Eagle Connecting Rods
- Thinking about running MSD Dis-2 Ignition
- Hi i need some help.
- Highest redline?
- Update On why my car wont start
- Oil pump failures need this crank kit!!!
- Intake Manifold - Torque?
- HELP, OIL LINE GASKET Problem
- Hand held scan tools?
- Intake Manifold Install Question?
- Expert Help: Screwed/not screwed
- Precision Turbos ????
- Where is our FUEL FILTER located?